Drive belt replacement
  1. Home
  2. Ashkelon
  3. Services
  4. Maxus
  5. Maintenance
  6. Drive belt replacement

Drive belt replacement for Maxus in Ashkelon

Place an ad

35 companies found

Machluf Yehuda Israel
  • Car Service
  • Open Will close at 17:00
  • Ashkelon
  • English, Hebrew
Call now
Viktor Shirytei Sika
  • Car Service
  • Open Will close at 15:00
  • Bitan Orly, 7
  • English, Hebrew, Russian
Call now
Arnold
  • Car Service
  • Open Will close at 17:00
  • Ha-Kishor St 14, Ashkelon
  • English, Hebrew
Call now
Garage Ototronic
  • Car Service
  • Open Will close at 18:00
  • HaNapah St 18, Ashkelon, Israel
  • English, Hebrew
Call now
Ha’Yachalom
  • Car Service
  • Open Will close at 18:30
  • Tsahal St 28, Ashkelon
  • English, Hebrew
Call now
Garage Tandem
  • Car Service
  • Open Will close at 16:30
  • HaMasger St 4, Ashkelon, Israel
  • English, Hebrew
Call now
Dani Garage Ashkelon
  • Car Service
  • Open Will close at 16:30
  • HaNagar St 3, Ashkelon
  • Hebrew
Call now
Victor
  • Car Service
  • Open Will close at 17:00
  • Ha-Kishor St 15, Ashkelon
  • English, Hebrew
Call now
Moto Klas
  • ShowroomCar Service
  • Open Will close at 17:30
  • Ha-Pninim St 21, Ashkelon
  • English, Hebrew
Call now
Garage Arik Dan
  • Car Service
  • Open Will close at 17:00
  • Tsahal St 39, Ashkelon
  • English, Hebrew
Call now
Peer, Ashkelon
  • Car Service
  • Open Will close at 17:00
  • Ort St 25, Ashkelon
  • Hebrew
Call now
Show all companies

Drive belt replacement

The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.