- Home
- Bat Yam
- Services
- Seres
- Air conditioning and heating
- Evaporator replacement
Evaporator replacement for Seres in Bat Yam
24 companies found
Garage Monitin
- Car Service
- Open Will close at 17:00
- Ha-Solelim St 9, Bat Yam
Rakefet
- Car Service
- Open Will close at 17:00
- Ort Israel St 52, Bat Yam
English ,Hebrew

Garage Gedi & David
- Car ServiceTire service
- Open Will close at 18:00
- Ort Israel St 38, Bat Yam, Israel
English ,Hebrew
Israel&Avi
- Car Service
- Open Will close at 18:00
- Menahem Yekuel St 13, Bat Yam
English ,Hebrew
Garage Yad
- Car Service
- Open Will close at 18:00
- Israel Vishengrad Ha-Masger St 3, Bat Yam, Israel
English ,Hebrew

Garage URV
- Car Service
- Open Will close at 17:00
- Menahem Yekuel St 3, Bat Yam
English ,French ,Russian
Garage Ha-Sadna
- Car Service
- Open Will close at 16:30
- HaOrgim St 18, Bat Yam
English ,Hebrew
Ha-Shoshanim
- Car Service
- Open Will close at 17:00
- Israel Vishengrad Ha-Masger St 3, Bat Yam
English ,Hebrew
Meretz Bat Yam
- Car Service
- Open Will close at 16:00
- Ehud Kinnamon St 37, Bat Yam
English ,Hebrew
Garage Ninio Aharon
- Car Service
- Open Will close at 17:00
- Ort Israel St 30, Bat Yam
English ,Hebrew
Amsalem Shlomo
- Car Service
- Open Will close at 17:00
- Yotvata St 17, Holon
English ,Hebrew

Garage Danin
- Car ServiceAuto parts
- Open Will close at 17:00
- Ort Israel St 34, Bat Yam
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.