Valve cover gasket replacement
  1. Home
  2. Haifa
  3. Services
  4. Engine
  5. Valve cover gasket replacement

Valve cover gasket replacement in Haifa

Place an ad

141 companies found

Ofan
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Newton St 3, Haifa
  • English, Hebrew
Call now
Ron
  • Car Service
  • Closed Will open on Sunday at 09:00
  • HaNapah St 26, Haifa
  • English, Hebrew
Call now
Garage Ram
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Bar Yehuda Road 32, Nesher
  • English, Hebrew, Russian
Call now
Garage Pisga, Haifa
  • Car Service
  • Closed Will open on Sunday at 07:00
  • Maklef St 60, Haifa
  • English, Hebrew
Call now
Garage Universal
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Derekh Yafo 100, Haifa
  • English, Hebrew
Call now
Garage Orion
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Haitstadyon St 21, Haifa
  • English, Hebrew, Russian
Call now
Service Center Ha'Kohav Rajad
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Newton St 4, Haifa
  • English, Hebrew
Call now
Garage Joy Koppel
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Melakha St 15, Haifa
  • English, Hebrew, Russian
Call now
Carmiel Motors
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Shaham St 40, Karmiel
  • English, Hebrew
Call now
Proter Otto Electro
  • Car Service
  • Closed Will open on Sunday at 07:30
  • HaHagana Ave 51, Haifa
  • English, Hebrew
Call now
Front Ha'Okef
  • Car ServiceAuto parts
  • Closed Will open on Monday at 08:00
  • אלמערי, Daliyat el-Carmel
  • Hebrew
Call now
Show all companies

Valve cover gasket replacement

The valve cover gasket should be replaced in the following cases: appearance of engine oil traces on the side walls of the cylinder head; assembling the engine after overhaul; detection of any gasket defects during repair. To replace the valve cover, disconnect the battery, remove the wire ends from the plugs, remove the valve cover attachments, remove the cover fasteners, remove the worn seal from the pockets, clean the working surface, apply a sealant and install a new gasket into the grooves.