Drive belt replacement for Lexus in Herzliya
16 companies found
Sahar
- Car Service
- Closed Will open on Monday at 08:00
- Hahoshlim St 11, Herzliya
English ,Hebrew

Tyres Center SH.I.
- Car ServiceTire serviceAuto parts
- Closed Will open on Monday at 07:30
- Hess St 27, Herzliya
English ,Hebrew
Doron&Yair
- Car Service
- Closed Will open on Monday at 07:30
- Maskit St 15, Herzliya
English ,Hebrew
Garage Ha'Sharon Beny
- Car Service
- Closed Will open on Monday at 08:00
- Galgalei ha-Plada St 5, Herzliya
English ,Hebrew

A.H.K. Ha-Achim
- Car ServiceTire service
- Closed Will open on Monday at 08:00
- Yad Harutsim St 5, Herzliya
English ,Hebrew
Millennium Pituah Garage
- Car Service
- Closed Will open on Monday at 07:30
- Medinat ha-Yehudim St 95, Herzliya
English ,Hebrew

Techno Cycle
- Car Service
- Closed Will open on Monday at 07:30
- Ha-Khermesh St 3, Herzliya
English ,Hebrew

Mosah Ha-Ir
- Car Service
- Closed Will open on Monday at 07:30
- Ha'Ilanot/Kanfe Nesharim, Herzliya
English ,Hebrew
Mosah Ganael
- Car Service
- Closed Will open on Monday at 08:00
- Galgalei ha-Plada St 19, Herzliya, Israel
English ,Hebrew

Garage Vashdi
- Car Service
- Closed Will open on Monday at 08:00
- Maskit St 15, Herzliya
English ,Hebrew
Baryh Garage
- Car Service
- Closed Will open on Monday at 07:30
- Hess St 29, Herzliya
Hebrew
Sun Motors
- Car Service
- Closed Will open on Monday at 07:30
- Galgalei ha-Plada St 23, Herzliya
English ,Hebrew
Drive belt replacement
Drive belt replacement
The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.