Evaporator replacement in Nazareth
44 companies found
Ha'Shlosha Nazareth
- Car Service
- Closed Will open on Thursday at 08:00
- Paulus ha-Shishi St 60, Nazareth
English ,Hebrew
Fahim Adi
- Car Service
- Closed Will open on Thursday at 08:00
- 4059 St 6, Nazareth
English ,Hebrew
Abu Ramzi
- Car ServiceEvacuator
- Closed Will open on Thursday at 08:00
- 5019 St 3, Nazareth
English ,Hebrew
Sharbel
- Car Service
- Closed Will open on Thursday at 07:30
- Al-Bishara St 35, Nazareth
English ,Hebrew
Gnaim Hitam
- Car Service
- Closed Will open on Thursday at 08:00
- אבורביה עמר, שכונה מזרחית 712/21, Nazareth, Israel
English ,Hebrew
Tenus Motors
- Tire service
- Closed Will open on Thursday at 08:00
- Nazareth Bypass, Nazareth
English ,Hebrew
Najamey Motors
- ShowroomCar Service
- Closed Will open on Thursday at 08:00
- Ha'Maayan 8, Natsrat-Ilit
English ,Hebrew
Ha`Minchara
- Car Service
- Closed Will open on Thursday at 08:30
- 129, Nazareth
English ,Hebrew
Aziza Fathi
- Car Service
- Closed Will open on Thursday at 08:30
- 2008 St 6, Nazareth
English ,Hebrew

Garage Hakim
- Car ServiceAuto parts
- Closed Will open on Thursday at 08:10
- מגדלי נצרת, Nazareth, Israel
English ,Hebrew ,Russian
Garage Brothers Avod Mercedes
- Car Service
- Closed Will open on Thursday at 08:30
- אבורביה עמר, שכונה מזרחית 712/21, Nazareth, Israel
English ,Hebrew

Garage Ahim Hatab
- Car Service
- Closed Will open on Thursday at 08:00
- Wadi el-Haj St 37, Nazareth
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.