Drive belt replacement
  1. Home
  2. Petah Tikva
  3. Services
  4. Cupra
  5. Maintenance
  6. Drive belt replacement

Drive belt replacement for Cupra in Petah Tikva

Place an ad

75 companies found

Yossi Segal
  • Car Service
  • Open Will close at 17:00
  • Bar Kochva St 77, Petah Tikva
  • English, Hebrew
Call now
Moked Ha`Rehev
  • Car Service
  • Open Will close at 16:00
  • Amal St 64, Petah Tikva
  • English, Hebrew
Call now
Shapira David
  • Car Service
  • Open Will close at 16:00
  • HaAluf David Marcus St 4, Petah Tikva
  • English, Hebrew
Call now
Rally Motor
  • Car Service
  • Open Will close at 18:00
  • HaAluf David Marcus St 41, Petah Tikva
  • English, Hebrew
Call now
Garage Ilan Hadj
  • Car Service
  • Open Will close at 17:00
  • Shlomo Michaelis St 5, Petah Tikva
  • English, Hebrew
Call now
Garage Lavia
  • Car Service
  • Open Will close at 17:00
  • HaYarkonim St 41, Petah Tikva
  • English, Hebrew
Call now
Tomer Rider
  • ShowroomCar Service
  • Open Will close at 17:00
  • Tsvi Bergman St 13, Petah Tikva
  • English, Hebrew
Call now
Garage Blue-White
  • Car Service
  • Open Will close at 17:00
  • Ha-Rekhev St 11, Petah Tikva, Israel
  • English, Hebrew
Call now
Gas Chish
  • Car Service
  • Open Will close at 20:00
  • Ef'al St 13, Petah Tikva
  • English, Hebrew
Call now
Cohen David Albert
  • Car Service
  • Open Will close at 17:00
  • Khalutsat ha-Pardesanut St 32, Petah Tikva
  • English, Hebrew
Call now
Yossi and Shlomo Garage
  • Car Service
  • Open Will close at 16:30
  • Modi'in St 16, Petah Tikva
  • Hebrew
Call now
Show all companies

Drive belt replacement

The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.