Replacing engine mountings
  1. Home
  2. Petah Tikva
  3. Services
  4. Cupra
  5. Engine
  6. Replacing engine mountings

Replacing engine mountings for Cupra in Petah Tikva

Place an ad

64 companies found

Sapfir Garage
  • Car Service
  • Closed Will open on Monday at 08:00
  • HaAluf David Marcus St 37, Petah Tikva
  • English, Hebrew, Russian
Call now
Mikhlol-Ran
  • Car Service
  • Closed Will open on Monday at 08:00
  • Baltimor St 4, Petah Tikva
  • English, Hebrew
Call now
Moked Ha`Rehev
  • Car Service
  • Closed Will open on Monday at 08:00
  • Amal St 64, Petah Tikva
  • English, Hebrew
Call now
Garage Yuri
  • Car Service
  • Closed Will open on Monday at 09:00
  • Ha-Mif'alim St 4, Petah Tikva
  • English, Hebrew
Call now
Ephraim
  • Car Service
  • Closed Will open on Monday at 08:00
  • Amal St 5, Petah Tikva
  • English, Hebrew
Call now
H.L.F.T.
  • Car Service
  • Closed Will open on Monday at 09:00
  • Avshalom Gisin st., 62
  • English, Hebrew
Call now
Gazit
  • Car Service
  • Closed Will open on Monday at 08:00
  • Basel St 13, Petah Tikva
  • English, Hebrew
Call now
Garage Zomet
  • Car Service
  • Closed Will open on Monday at 07:30
  • HaYarkonim St 33, Petah Tikva
  • English, Hebrew
Call now
Show all companies

Replacing engine mountings

The hydraulic mounts (support cushions) can be operated for about 100 - 250 thousand operational kilometers. However, when operating in difficult conditions, they must be replaced much earlier due to wear. The procedure for replacing the front mount can be as follows: remove the mountings of the support cushion to the suspension cross member bracket, raise the engine, remove the old mount and install a new one. Replacing the rear engine mount includes the following actions: removing the crankcase guard, removing the rack mounts from the engine side, removing the rear mount and installing a new one.