Evaporator replacement for Lancia in Petah Tikva
85 companies found
Ktifa Car Electricity
- Car Service
- Open Will close at 17:00
- Bar Kokhba 13, Petah Tikva
English ,Hebrew
Moshe Zer
- Car Service
- Closed Will open on Wednesday at 07:30
- Ha-Rekhev St 5, Petah Tikva
English ,Hebrew
Gazit
- Car Service
- Open Will close at 17:00
- Basel St 13, Petah Tikva
English ,Hebrew

Elbaz Haim, Petah Tikva
- Car Service
- Open Will close at 17:00
- Amal St 4, Petah Tikva
English ,Hebrew

Beni Radiator
- Car Service
- Closed Will open on Wednesday at 08:00
- Ben Tsiyon Galis St 17, Petah Tikva
English ,Hebrew
D. Nahum
- Car Service
- Open Will close at 17:00
- Avshalom Gissin St 106, Petah Tikva
English ,Hebrew
Shemesh Yossi
- Car Service
- Closed Will open on Wednesday at 08:00
- HaAluf David Marcus St 54, Petah Tikva
English ,Hebrew
Yossi and Shlomo Garage
- Car Service
- Closed Will open on Wednesday at 07:30
- Modi'in St 16, Petah Tikva
Hebrew
Death Paddy
- Car Service
- Open Will close at 17:00
- Tira
English ,Hebrew

Garage S.R.
- Car Service
- Open Will close at 17:30
- Khalutsat ha-Pardesanut St 25, Petah Tikva
English ,Hebrew
Mikhlol-Ran
- Car Service
- Closed Will open on Wednesday at 08:00
- Baltimor St 4, Petah Tikva
English ,Hebrew

Eli Car Service, Petah Tikva
- Car Service
- Closed Will open on Wednesday at 08:00
- Ha-Yetsira St 8, Petah Tikva
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.