Replacing engine mountings for Lancia in Petah Tikva
64 companies found
Sapfir Garage
- Car Service
- Closed Will open on Wednesday at 08:00
- HaAluf David Marcus St 37, Petah Tikva
English ,Hebrew ,Russian
Daboul Eyal
- Car Service
- Closed Will open on Wednesday at 07:00
- Ef'al St 7, Petah Tikva
English ,Hebrew
Garage MFC
- Car Service
- Closed Will open on Wednesday at 08:00
- Emile Zola St 22, Petah Tikva
English ,Hebrew
Shlomo Yavo
- Car Service
- Closed Will open on Wednesday at 08:30
- Nakhshon St 13, Petah Tikva
English ,Hebrew
Petah Tikva
- Car Service
- Closed Will open on Wednesday at 08:00
- Avshalom Gissin St 72, Petah Tikva
English ,Hebrew
Garage Far Petah Tikva
- Car Service
- Closed Will open on Wednesday at 08:00
- HaAluf David Marcus St 27, Petah Tikva
English ,Hebrew
Komfiuzecar
- Car Service
- Closed Will open on Wednesday at 08:00
- Nakhshon St 19, Petah Tikva
English ,Hebrew
Garage S.R.
- Car Service
- Closed Will open on Wednesday at 08:00
- Khalutsat ha-Pardesanut St 25, Petah Tikva
English ,Hebrew
Garage Nikton
- Car Service
- Closed Will open on Wednesday at 08:30
- Amal St 46, Petah Tikva
English ,Hebrew
Garage Blue-White
- Car Service
- Closed Will open on Wednesday at 08:00
- Ha-Rekhev St 11, Petah Tikva, Israel
English ,Hebrew
Garage Zomet
- Car Service
- Closed Will open on Wednesday at 07:30
- HaYarkonim St 33, Petah Tikva
English ,Hebrew
Garage Ha'Koah
- Car Service
- Closed Will open on Wednesday at 06:30
- Ben Tsiyon Galis St 42, Petah Tikva
English ,Hebrew ,Russian
Replacing engine mountings
Replacing engine mountings
The hydraulic mounts (support cushions) can be operated for about 100 - 250 thousand operational kilometers. However, when operating in difficult conditions, they must be replaced much earlier due to wear. The procedure for replacing the front mount can be as follows: remove the mountings of the support cushion to the suspension cross member bracket, raise the engine, remove the old mount and install a new one. Replacing the rear engine mount includes the following actions: removing the crankcase guard, removing the rack mounts from the engine side, removing the rear mount and installing a new one.