Drive belt replacement for City Transformer in Tel Aviv District
340 companies found
H.M- motors
- Car ServiceAuto parts
- Closed Will open on Monday at 07:30
- Herzl St 113, Tel Aviv-Yafo
English ,Hebrew
Garage Classic
- Car Service
- Closed Will open on Monday at 08:00
- Shrira Ga'on St 1, Tel Aviv-Yafo
English ,Hebrew
Garage Ephraim
- Car Service
- Closed Will open on Monday at 07:30
- HaKishon St 15, Bnei Brak
English ,Hebrew
Motonel
- Car Service
- Closed Will open on Monday at 08:30
- מוסך מוטונל
English ,Hebrew
Garage Shaft
- Car Service
- Closed Will open on Monday at 07:30
- Khoma u-Migdal St 22, Tel Aviv-Yafo
English ,Hebrew
Garage Ha`Daykanim
- Car Service
- Closed Will open on Monday at 08:00
- HaRav Kahanman St 98, Bnei Brak, Israel
English ,Hebrew
General
- Car Service
- Closed Will open on Monday at 07:30
- Ma'apilei Salvador St 20, Tel Aviv-Yafo
English ,Hebrew
Ravit
- Car Service
- Closed Will open on Monday at 08:00
- Shalma Rd 46, Tel Aviv-Yafo
English ,Hebrew
Millennium Pituah Garage
- Car Service
- Closed Will open on Monday at 07:30
- Medinat ha-Yehudim St 95, Herzliya
English ,Hebrew
Avner Et Gideon
- Car Service
- Closed Will open on Monday at 08:00
- Rashi St 8, Bnei Brak
English ,Hebrew
Moto Scooter
- Car Service
- Closed Will open on Monday at 07:30
- Shlabim St 12, Tel Aviv-Yafo, Israel
English ,Hebrew
Garage Eli Almog
- Car Service
- Closed Will open on Monday at 08:00
- Apak St 20, Tel Aviv-Yafo, Israel
English ,Hebrew
Drive belt replacement
Drive belt replacement
The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.