Camshaft position sensor replacement
  1. Home
  2. Tel Aviv District
  3. Services
  4. RAM
  5. Electrical equipment
  6. Camshaft position sensor replacement

Camshaft position sensor replacement for RAM in Tel Aviv District

311 companies found

Garage David Moshe
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Yerushalayim St 147, Azor
  • English, Hebrew
Call now
Femi Premium
  • Car Service
  • Open
  • Ha-Mashbir St 4, Holon
  • English, Hebrew
Call now
Baryh Garage
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Hess St 29, Herzliya
  • Hebrew
Call now
Reuter Joe
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Banai St 29, Holon
  • English, Hebrew
Call now
Nahum Gili Garage
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Melakha St 52, Holon
  • English, Hebrew
Call now
Si O Center
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Kharoshet St 26, Or Yehuda
  • English, Hebrew
Call now
Eli et Zion
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaOrgim St 15, Bat Yam
  • English, Hebrew
Call now
Auto Alex
  • Car Service
  • Closed Will open on Sunday at 07:00
  • Israel Vishengrad Ha-Masger St 7, Bat Yam
  • English, Hebrew, Russian
Call now
Garage Monitin
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Solelim St 9, Bat Yam
Call now
Otometr Dani
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaYarkon St 13a, Tel Aviv-Yafo
  • English, Hebrew
Call now
Amir T-A
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Soncino St 20, Tel Aviv-Yafo
  • English, Hebrew
Call now
Car Services of Parking Garages
  • Car ServiceTire serviceWash station
  • Closed Will open on Sunday at 08:00
  • Eilat St 36, Holon
  • English, Hebrew, Russian
Call now
Show all companies

Camshaft position sensor replacement

It may be required to replace the camshaft position sensor in the presence of the following signs: increased fuel consumption, engine starting problems, and lower performance. The procedure for dismantling involves disconnecting electrical connector from the sensor, removing the air filter housing, the upper timing case, the support bracket, the sensor mounts and the sensor itself. Installation of a new device is carried out in the reverse order.