- Home
- Tel Aviv-Yafo
- Services
- LEVC
- Electrical equipment
- Camshaft position sensor replacement
Camshaft position sensor replacement for LEVC in Tel Aviv-Yafo
143 companies found

Garage Avi Zalach
- Car Service
- Closed Will open on Sunday at 07:00
- Soncino St 15, Tel Aviv-Yafo, Israel
English ,Hebrew
Garage Siksik
- Car Service
- Closed Will open on Sunday at 08:00
- Derekh Ben-Zvi 13, Tel Aviv-Yafo
English ,Hebrew
Edmund
- Car Service
- Closed Will open on Sunday at 08:30
- Yisra'el mi-Salant St 46, Tel Aviv-Yafo
English ,Hebrew
Risk
- Car Service
- Closed Will open on Sunday at 07:30
- Poriya St 6, Tel Aviv-Yafo
English ,Hebrew
David Malki
- Car Service
- Closed Will open on Sunday at 08:30
- Schnitzler St 23, Tel Aviv-Yafo
English ,Hebrew

Itsik Kivyney Front
- Car Service
- Closed Will open on Sunday at 08:00
- Gershon Shatz St 31, Tel Aviv-Yafo
English ,Hebrew

Mosah Glaubah
- Car Service
- Closed Will open on Sunday at 08:00
- Paul Kor St 24, Tel Aviv-Yafo
English ,Hebrew
Garage Hipushit
- Car Service
- Closed Will open on Sunday at 08:00
- Derekh Ben-Zvi 37, Tel Aviv-Yafo
English ,Hebrew
Ha`Ach Ha`Gadol
- Car Service
- Closed Will open on Sunday at 07:30
- Gershon Shatz St 42, Tel Aviv-Yafo
English ,Hebrew
Garage Deri Brothers
- Car Service
- Closed Will open on Sunday at 08:00
- Khever ha-Le'umim St 29, Tel Aviv-Yafo
English ,Hebrew
Garage Van Motors
- Car Service
- Closed Will open on Sunday at 07:30
- Hayei Adam St 7, Tel Aviv-Yafo
English ,Hebrew ,Russian
Garage Fiaton
- Car Service
- Closed Will open on Sunday at 07:30
- 67771, Ha-Rekhev St 12, Tel Aviv-Yafo, Israel
English ,Hebrew
Camshaft position sensor replacement
Camshaft position sensor replacement
It may be required to replace the camshaft position sensor in the presence of the following signs: increased fuel consumption, engine starting problems, and lower performance. The procedure for dismantling involves disconnecting electrical connector from the sensor, removing the air filter housing, the upper timing case, the support bracket, the sensor mounts and the sensor itself. Installation of a new device is carried out in the reverse order.