- Home
- Tel Aviv-Yafo
- Services
- LEVC
- Steering
- Steering gear replacement
Steering gear replacement for LEVC in Tel Aviv-Yafo
129 companies found
Garage Raling
- Car Service
- Closed Will open on Sunday at 07:30
- Schnitzler St 21, Tel Aviv-Yafo
English ,Hebrew

Erez Motorcycles
- Car Service
- Closed Will open on Sunday at 08:00
- Soncino St 1, Tel Aviv-Yafo, Israel
English ,Hebrew

Itsik Kivyney Front
- Car Service
- Closed Will open on Sunday at 08:00
- Gershon Shatz St 31, Tel Aviv-Yafo
English ,Hebrew
Garage Perfect
- Car Service
- Closed Will open on Sunday at 08:00
- Shrira Ga'on St 8, Tel Aviv-Yafo
English ,Hebrew

Garage Moti Yael Leasing
- ShowroomCar Service
- Closed Will open on Sunday at 08:00
- Ruhama St 2, Tel Aviv-Yafo, Israel
English ,Hebrew
Hinawi Bishara
- Car Service
- Closed Will open on Sunday at 08:00
- Ben Akhituv St 20, Tel Aviv-Yafo
English ,Hebrew
Tabib Avi Grand Prix
- Car Service
- Closed Will open on Sunday at 07:30
- Yitzhak Sadeh St 5, Tel Aviv-Yafo
English ,Hebrew
Auto Bedek
- Car test
- Closed Will open on Sunday at 07:30
- Totseret ha-Arets St 20, Tel Aviv-Yafo
English ,Hebrew
Tivat Noach
- Car ServiceEvacuator
- Closed Will open on Sunday at 08:00
- Yoqneam St 13, Tel Aviv-Yafo
English ,Hebrew
C.M.I Cohen
- Car Service
- Closed Will open on Sunday at 07:30
- Shefa Tal St 9, Tel Aviv-Yafo
English ,Hebrew
Ha`Herzl Barrel Tip Top
- Car Service
- Closed Will open on Sunday at 08:00
- HaSolelim St 8, Tel Aviv-Yafo
English ,Hebrew

Garage Tsfira
- Car Service
- Closed Will open on Sunday at 08:00
- HaTsfira St 17, Tel Aviv-Yafo, Israel
English ,Hebrew
Steering gear replacement
Steering gear replacement
It may be required to replace the steering gear if you notice the following signs: traces of oil under the car, steering wheel turning problems, steering wheel backlash, as well as knocking sounds in the gearbox. The general procedure for replacing a part is as follows: use a puller to remove the steering lever from the axle, remove the finishing panel located under the devices, disconnect the shaft from the gearbox, remove the thermal insulation shield, dismantle the gear and install a new one.