- Home
- Tel Aviv-Yafo
- Services
- Mercedes
- Steering
- Steering gear replacement
Steering gear replacement for Mercedes in Tel Aviv-Yafo
135 companies found
Garage Ha'Mair Tel Aviv
- Car Service
- Closed Will open on Friday at 07:00
- Derekh Ben-Zvi 11, Tel Aviv-Yafo
English ,Hebrew
Garage Gag 2004
- Car Service
- Closed Will open on Friday at 07:30
- Derech Menachem Begin 62, Tel Aviv-Yafo, Israel
English ,Hebrew
Garage Dan
- Car Service
- Closed Will open on Friday at 08:00
- Elifelet St 5, Tel Aviv-Yafo, Israel
English ,Hebrew
Ventura
- Car Service
- Closed Will open on Sunday at 07:00
- Tversky St 16, Tel Aviv-Yafo
English ,Hebrew
Eli Welder and Uri Eli Welder and Uri Milling Machine Operator
- Car Service
- Closed Will open on Sunday at 08:00
- Yitzhak Sadeh St 34, Tel Aviv-Yafo
English ,Hebrew

Garage Nahalat Yitzhak
- Car Service
- Closed Will open on Friday at 07:30
- Hayei Adam St 10, Tel Aviv-Yafo
English ,Hebrew

Garage Moshon, Tel Aviv
- Car Service
- Closed Will open on Friday at 08:00
- Levanda St 42, Tel Aviv-Yafo, Israel
English ,Hebrew
Saar
- Car Service
- Closed Will open on Friday at 07:00
- Shoken St 17, Tel Aviv-Yafo
English ,Hebrew
Tabib Avi Grand Prix
- Car Service
- Closed Will open on Friday at 07:30
- Yitzhak Sadeh St 5, Tel Aviv-Yafo
English ,Hebrew
Garage Samson Tel Aviv
- Car ServiceTire service
- Closed Will open on Friday at 08:00
- Hagana Rd 51, Tel Aviv-Yafo
English ,Hebrew
Edmund
- Car Service
- Closed Will open on Sunday at 08:30
- Yisra'el mi-Salant St 46, Tel Aviv-Yafo
English ,Hebrew
Star Cycle
- ShowroomCar Service
- Closed Will open on Friday at 08:00
- Golomb St 60, Tel Aviv-Yafo
English ,Hebrew
Steering gear replacement
Steering gear replacement
It may be required to replace the steering gear if you notice the following signs: traces of oil under the car, steering wheel turning problems, steering wheel backlash, as well as knocking sounds in the gearbox. The general procedure for replacing a part is as follows: use a puller to remove the steering lever from the axle, remove the finishing panel located under the devices, disconnect the shaft from the gearbox, remove the thermal insulation shield, dismantle the gear and install a new one.