Drive belt replacement
  1. Home
  2. Tveria
  3. Services
  4. GMC
  5. Maintenance
  6. Drive belt replacement

Drive belt replacement for GMC in Tveria

17 companies found

Tiberias Motors Garage
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaHashmal St 4, Tiberias
  • English, Hebrew
Call now
Nisim Bahar
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaMalaha 27, Teberias
  • English, Hebrew
Call now
Zachi
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Brenner St 137, Tiberias
  • English, Hebrew
Call now
Garage Ha'Karam
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaMelacha St 4, Tiberias
  • English, Hebrew
Call now
Bendley George
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Yehuda Halevi St 113, Tiberias
  • English, Hebrew
Call now
Ronen
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Pika St 2, Tiberias
  • English, Hebrew
Call now
Kav Ha`Ofek
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Brurya St 8, Tiberias
  • English, Hebrew
Call now
Bepi
  • Car Service
  • Closed Will open on Sunday at 08:30
  • Yehuda Halevi St 0, Tiberias
  • English, Hebrew
Call now
Garage Cohen Alfred
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Big Poria Complex, Tveria Illit, Tiberias
  • English, Hebrew
Call now
NASA Service Center
  • Car Service
  • Open Will close at 17:00
  • Leshem St 1
  • English, Hebrew
Call now
Show all companies

Drive belt replacement

The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.