Valve cover gasket replacement
  1. Home
  2. Yehud Monosson
  3. Services
  4. Cupra
  5. Engine
  6. Valve cover gasket replacement

Valve cover gasket replacement for Cupra in Yehud Monosson

19 companies found

Amerika
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Shabazi St 19, Yehud-Monosson
  • English, Hebrew
Call now
Meish Izhak
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Herzl St 23, Yehud-Monosson
  • English, Hebrew
Call now
Ezekiel Kashi
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Altalef St 25, Yehud-Monosson
  • English, Hebrew
Call now
Garage Dahan Nathaniel
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Herzl St 23, Yehud-Monosson
  • English, Hebrew
Call now
Michael Sharfi
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaTa'asiya St 42, Yehud-Monosson
  • English, Hebrew
Call now
Rotem Paz
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Altalef St 25, Yehud-Monosson
  • English, Hebrew
Call now
Garage Ha'Atzmaut Yehud
  • Car Service
  • Closed Will open on Sunday at 07:30
  • HaTa'asiya St 20, Yehud-Monosson
  • English, Hebrew
Call now
Nir Hasson
  • Car Service
  • Closed Will open on Sunday at 09:00
  • Derech HaAtsma'ut 45, Yehud
  • English, Hebrew
Call now
Mualem Zadok
  • Car Service
  • Closed Will open on Sunday at 09:00
  • Altelf Abraham 25, Yehud
  • English, Hebrew
Call now
Car Zone
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Weizman St 33, Yehud-Monosson
  • English, Hebrew
Call now
Masa 1996
  • Car Service
  • Closed Will open on Sunday at 07:00
  • HaTa'asiya St 28, Yehud-Monosson
  • English, Hebrew
Call now
Show all companies

Valve cover gasket replacement

The valve cover gasket should be replaced in the following cases: appearance of engine oil traces on the side walls of the cylinder head; assembling the engine after overhaul; detection of any gasket defects during repair. To replace the valve cover, disconnect the battery, remove the wire ends from the plugs, remove the valve cover attachments, remove the cover fasteners, remove the worn seal from the pockets, clean the working surface, apply a sealant and install a new gasket into the grooves.