Measurement of engine compression
  1. Home
  2. Yehud Monosson
  3. Services
  4. JAC
  5. Engine
  6. Measurement of engine compression

Measurement of engine compression for JAC in Yehud Monosson

Place an ad

19 companies found

Ezekiel Kashi
  • Car Service
  • Open Will close at 17:30
  • Altalef St 25, Yehud-Monosson
  • English, Hebrew
Call now
Meish Izhak
  • Car Service
  • Open Will close at 17:00
  • Herzl St 23, Yehud-Monosson
  • English, Hebrew
Call now
Nir Hasson
  • Car Service
  • Open Will close at 18:00
  • Derech HaAtsma'ut 45, Yehud
  • English, Hebrew
Call now
Garage Ha'Atzmaut Yehud
  • Car Service
  • Open Will close at 17:00
  • HaTa'asiya St 20, Yehud-Monosson
  • English, Hebrew
Call now
Garage Ron Kor
  • Car Service
  • Open Will close at 17:00
  • Altalef St 3, Yehud-Monosson
  • English, Hebrew
Call now
Garage Dori
  • Car Service
  • Open Will close at 16:30
  • Altalef St 7, Yehud-Monosson
  • English, Hebrew
Call now
Garage Dr. Bug
  • Car Service
  • Open Will close at 17:00
  • Altalef St 25, Yehud-Monosson
  • English, Hebrew
Call now
Ha`Achim Mimun
  • Car Service
  • Open Will close at 16:30
  • Derech HaAtsma'ut 45, Yehud
  • English, Hebrew
Call now
Amerika
  • Car Service
  • Open Will close at 16:00
  • Shabazi St 19, Yehud-Monosson
  • English, Hebrew
Call now
Rotem Paz
  • Car Service
  • Open Will close at 17:00
  • Altalef St 25, Yehud-Monosson
  • English, Hebrew
Call now
Car Zone
  • Car Service
  • Open Will close at 17:00
  • Weizman St 33, Yehud-Monosson
  • English, Hebrew
Call now
Olam Ha`Rechev
  • Car Service
  • Open Will close at 17:00
  • Derech HaAtsma'ut 2, Yehud
  • English, Hebrew
Call now
Show all companies

Measurement of engine compression

Engine compression measurement is a way of assessing the CPG (cylinder-piston group). A compression meter is used to measure the engine compression. The compression is measured with the fuel supply turned off, while the engine’s temperature doesn’t exceed 90C. Compression is measured with open and closed throttle valves. It is also possible to carry out measurement with a cold engine. Based on the results of measurements, a faulty cylinder can be identified.