- Home
- Yehud Monosson
- Services
- Mitsubishi
- Air conditioning and heating
- Evaporator replacement
Evaporator replacement for Mitsubishi in Yehud Monosson
23 companies found
Michael Sharfi
- Car Service
- Closed Will open at 08:00
- HaTa'asiya St 42, Yehud-Monosson
English ,Hebrew
Ha`Achim Mimun
- Car Service
- Closed Will open at 07:30
- Derech HaAtsma'ut 45, Yehud
English ,Hebrew
Garage Itzhak Levi
- Car Service
- Closed Will open at 08:00
- Derech HaAtsma'ut 6, Yehud, Israel
English ,Hebrew
Meish Izhak
- Car Service
- Closed Will open at 08:00
- Herzl St 23, Yehud-Monosson
English ,Hebrew
Garage Naman
- Car Service
- Closed Will open at 08:00
- Shabazi St 10, Yehud-Monosson
English ,Hebrew
Olam Ha`Rechev
- Car Service
- Closed Will open at 08:00
- Derech HaAtsma'ut 2, Yehud
English ,Hebrew
Eddie Weiss
- Car Service
- Closed Will open at 08:00
- Derech HaAtsma'ut 24, Yehud
English ,Hebrew
Garage Ron Kor
- Car Service
- Closed Will open at 08:00
- Altalef St 3, Yehud-Monosson
English ,Hebrew
Car Zone
- Car Service
- Closed Will open at 08:00
- Weizman St 33, Yehud-Monosson
English ,Hebrew
Nir Hasson
- Car Service
- Closed Will open at 09:00
- Derech HaAtsma'ut 45, Yehud
English ,Hebrew
Garage Dori
- Car Service
- Closed Will open at 07:30
- Altalef St 7, Yehud-Monosson
English ,Hebrew
Mualem Zadok
- Car Service
- Closed Will open at 09:00
- Altelf Abraham 25, Yehud
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.