Drive belt replacement

Drive belt replacement in Ashdod

70 companies found

Mosah Boaz, Ashdod
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • HaMada St 31, Ashdod
  • English, Hebrew
Call now
Ralex Handasa
  • ShowroomCar Service
  • Open Will close at 18:00
  • Bney Brit Blv, Junction Namal Ashdod
  • English, Hebrew, Russian
Call now
Zabari Tractors
  • ShowroomCar Service
  • Closed Will open on Wednesday at 09:00
  • Ha-Amal St 34, Ashdod
  • English, Hebrew
Call now
Ha`Ir
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • Ba'alei HaMelacha St 3, Ashdod
  • English, Hebrew
Call now
Clinton
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • Nir Galim Road 2401, Ashdod
  • English, Hebrew
Call now
Tzameret
  • Car Service
  • Open Will close at 18:30
  • Ha-Ashlag St 33, Ashdod
  • English, Hebrew
Call now
Charash Ashdod 2
  • Car Service
  • Closed Will open on Wednesday at 07:00
  • Ha-Kidma St 14, Ashdod
  • English, Hebrew
Call now
Garage Nikolay
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • Ha-Avoda St 54, Ashdod
  • English, Hebrew, Russian
Call now
Talnoa
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • HaOferet St 4, Ashdod
  • English, Hebrew
Call now
Talit Ha`Saim
  • Car Service
  • Open Will close at 18:00
  • HaMada St 4, Ashdod
  • English, Hebrew
Call now
Auto Club
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • Ha-Avoda St 54, Ashdod
  • English, Hebrew
Call now
Auto Ran
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • Hayozer St 7, Ashdod
  • English, Hebrew
Call now
Show all companies

Drive belt replacement

The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.