Drive belt replacement

Drive belt replacement in Ashkelon

51 companies found

Machluf Yehuda Israel
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Ashkelon
  • English, Hebrew
Call now
Dani Garage Ashkelon
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaNagar St 3, Ashkelon
  • Hebrew
Call now
A.M. Mehonaut
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Yetsul St 1, Ashkelon
  • English, Hebrew
Call now
Viktor Shirytei Sika
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Bitan Orly, 7
  • English, Hebrew, Russian
Call now
Ha’Yachalom
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Tsahal St 28, Ashkelon
  • English, Hebrew
Call now
Opel
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Merkava St 27, Ashkelon
  • English, Hebrew
Call now
Mosah Zuriel
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Mekhuga St 32, Ashkelon
  • Hebrew
Call now
Garage A.R.
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Ha-Kishor St 16, Ashkelon, Israel
  • English, Hebrew, Russian
Call now
Sheetrit Service Center
  • Car Service
  • Closed Will open on Sunday at 07:30
  • Ha-Yetsul St 3, Ashkelon
  • English, Hebrew, Russian
Call now
Aviad Tomer
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Sderot HaTa'asiya 61, Ashkelon
  • English, Hebrew
Call now
Victor Ben Yishai
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaSargel St 602, Ashkelon
  • English, Hebrew
Call now
Show all companies

Drive belt replacement

The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.