- Home
- Beer Tuvia Regional Council
- Services
- Air conditioning and heating
- Evaporator replacement
Evaporator replacement in Beer Tuvia
17 companies found
Neeman
- Car Service
- Closed Will open on Sunday at 07:30
- Tlamim St, Be'er Tuvia
English ,Hebrew
Bernstein Israel
- Car Service
- Closed Will open on Sunday at 08:00
- Talmei Yehi'el
Garage Dor
- Car ServiceTire service
- Closed Will open on Sunday at 07:00
- Ha-Rishonim St, Be'er Tuvia, Israel
English ,Hebrew
Machlon Alsheikh
- Car Service
- Closed Will open on Sunday at 07:30
- Kannot
English ,Hebrew
Car service South
- Car Service
- Closed Will open on Sunday at 07:30
- א.ת. באר טוביה, ניר 5
English ,Hebrew
Kvuzat Ha'Argaz
- Showroom
- Closed Will open on Sunday at 08:00
- 34, Timorim
English ,Hebrew
Behenut Ha-Tikon
- Car Service
- Closed Will open on Sunday at 08:00
- Yarok St 44
English ,Hebrew
Garage Reem 86
- Car Service
- Closed Will open on Sunday at 08:00
- Ba'alei Melacha St 11, Haifa
English ,Hebrew
Orabi
- Car Service
- Closed Will open on Sunday at 07:00
- Ha-Rishonim St, Be'er Tuvia
English ,Hebrew
Tzach Or T.Z.
- Car Service
- Closed Will open on Sunday at 08:00
- Tnuva St
English ,Hebrew
Yehiel Vehicle Services
- Car Service
- Closed Will open on Sunday at 08:00
- Unnamed Road, Azrikam
English ,Hebrew
Amcol
- Car Service
- Closed Will open on Sunday at 08:00
- Kannot Industrial Area, Gedera
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.