ECU replacement
  1. Home
  2. Bet Shemesh
  3. Services
  4. Electrical equipment
  5. ECU replacement

ECU replacement in Bet Shemesh

24 companies found

Ayelet HaShahar
  • Car Service
  • Open Will close at 16:30
  • Yig'al Alon Ave 19, Beit Shemesh
  • English, Hebrew
Call now
Diesel Gar-Tov
  • Car Service
  • Open Will close at 17:00
  • Ha-Har St 3
  • English, Hebrew
Call now
Ha'Kol Le'Rehev, Bet Shemesh
  • Car ServiceAuto parts
  • Open Will close at 18:00
  • Ha-Masger St 18, Bet Shemesh
  • English, Hebrew
Call now
S.B.L.L Service Car
  • Car ServiceWash station
  • Open Will close at 18:00
  • Ha-Masger St 15, Bet Shemesh
  • English, Hebrew
Call now
Tsameret Bet Shemesh
  • Car Service
  • Open Will close at 17:00
  • Ha-Masger St 9, Bet Shemesh
  • English, Hebrew
Call now
Garage Trucks Beit Shemesh
  • Car Service
  • Open Will close at 17:00
  • מרכז שירות למשאיות בית שמש בע"מ
  • English, Hebrew
Call now
Garage Ha`Ir
  • Car Service
  • Open Will close at 17:00
  • Ha-Masger St 13, Bet Shemesh
  • English, Hebrew
Call now
Michael Kadosh
  • Car Service
  • Open Will close at 17:00
  • 3857 St, Bet Shemesh
  • English, Hebrew
Call now
Avner Michaeli
  • Car Service
  • Open Will close at 17:00
  • Nesher Industrial Zone, Bet Shemesh
  • English, Hebrew
Call now
Atar
  • Car Service
  • Open Will close at 18:00
  • Smadar St 136, Bet Shemesh
  • English, Hebrew
Call now
Shlomo Naor Group
  • Car ServiceAuto parts
  • Open Will close at 17:00
  • Granit St 9
  • English, Hebrew
Call now
Mifgash Samson
  • Car Service
  • Open Will close at 18:00
  • Beit Shemesh
  • English, Hebrew
Call now
Show all companies

ECU replacement

A malfunction of the electronic control unit (ECU) is indicated by the “Check Engine” sensor, and computer diagnostics will be required to clarify the problem. The main symptoms of a malfunctioning ECU are such engine problems as a failure, inability to start. Replacing the engine control unit begins with determining its location. Before removing the unit, disconnect the battery, disconnect the blocks with wires from the control unit, remove the device and install a new one. After that, check the operability of the electronic control unit. It may be required to adapt the device.