- Home
- Bnei Brak
- Services
- Air conditioning and heating
- Evaporator replacement
Evaporator replacement in Bnei Brak
49 companies found
Service Autoartil
- Car Service
- Closed Will open at 08:00
- Lekhi St 24, Bnei Brak
English ,Hebrew
Ayalon
- Car Service
- Closed Will open at 08:30
- Ha-Yarkon St 25, Bnei Brak
English ,Hebrew
Mosah Yaakov
- Car Service
- Closed Will open at 08:00
- Ha-Yarkon St 66, Bnei Brak
Hebrew
Garage Moshe
- Car Service
- Closed Will open at 08:00
- Ezra St 36, Bnei Brak
English ,Hebrew
Garage Rahamim, Bnei Brak
- Car Service
- Closed Will open at 07:00
- Barukh Hirsch St 26, Bnei Brak
English ,Hebrew
Garage Galkor
- Car Service
- Closed Will open at 08:00
- Ha-Yarkon St 27, Bnei Brak
Hebrew
Garage Ha'Tomer
- Car Service
- Closed Will open at 08:00
- Ha-Yarkon St 66, Bnei Brak
English ,Hebrew
Garage Yakov Israel
- Car Service
- Closed Will open at 07:30
- Ha-Yarden St 28, Bnei Brak, Israel
English ,Hebrew
D&V Motors
- Car Service
- Closed Will open at 08:30
- Ha-Yarkon St 37, Bnei Brak
English ,Hebrew
Garage Moti Duchi
- Car Service
- Closed Will open at 08:00
- Ha-Yarkon St 36, Bnei Brak, Israel
English ,Hebrew
Garage Moti Bnei Brak
- Car Service
- Closed Will open at 07:30
- Ha-Yarkon St 8, Bnei Brak, Israel
English ,Hebrew
David Yosef
- Car Service
- Closed Will open at 07:30
- HaRav Kahanman St 139, Bnei Brak
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.