- Home
- Emek Hefer Regional Council
- Services
- Air conditioning and heating
- Evaporator replacement
Evaporator replacement in Emek Hefer
15 companies found
Garage Kibbutz Maabarot
- Car Service
- Closed Will open on Sunday at 07:00
- Ma'barot, Ma'abarot
English ,Hebrew
Garage Prigat
- Car Service
- Closed Will open on Sunday at 07:30
- Givat Haim
Hebrew
Hefer Car Services
- Car Service
- Closed Will open on Sunday at 07:30
- Gesher HaEts 10
English ,Hebrew
A.Z. Automatic
- Car Service
- Closed Will open at 07:30
- Beit HaRishonim St 18
English ,Hebrew
Garage Ein Ha'Horesh
- Car Service
- Closed Will open on Sunday at 07:00
- Ein HaHoresh
English ,Hebrew
Garage Givat Haim Ha'Meuhad
- Car Service
- Closed Will open on Sunday at 07:30
- Unnamed Road, Givat Haim
English ,Hebrew
Meir Emek Hefer
- Car Service
- Closed Will open at 07:15
- 5700, Israel
English ,Hebrew
Keren Garage
- Car Service
- Closed Will open at 07:45
- He-Kharish St 17
English ,Hebrew
Garage Benni, Beit Herut
- Car Service
- Closed Will open at 07:00
- Derech HaHadarim 100, Beit Herut
English ,Hebrew
Z.L.A. Earthworks Equipment
- ShowroomCar Service
- Closed Will open at 07:30
- Ha-Batsir St 46
English ,Hebrew
Haor Service
- Car Service
- Closed Will open at 08:00
- Gesher HaEts 44
Hebrew
Ha`Egoz Bnei Zion
- Car Service
- Closed Will open at 08:00
- Gesher HaEts 20, 3877701
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.