- Home
- Hadera
- Services
- Maintenance
- Drive belt replacement
Drive belt replacement in Hadera
53 companies found

Garage A.M. Hadera
- Car Service
- Closed Will open on Tuesday at 08:00
- Yehudei Pki'in St 11, Hadera
English ,Hebrew

Cohen Motors
- Showroom
- Closed Will open on Tuesday at 08:30
- Manai St 1, Hadera
English ,Hebrew
Amit Cohen
- Car Service
- Closed Will open on Tuesday at 07:30
- Friedlander St 10, Hadera
English ,Hebrew
Garage Ihalom
- Car Service
- Closed Will open on Tuesday at 08:00
- Friedlander St 12, Hadera
English ,Hebrew
Casey Brothers Garage
- Car Service
- Closed Will open on Tuesday at 07:30
- מוסך אחים קייסי
English ,Hebrew
Aviv
- Car Service
- Closed Will open on Tuesday at 08:00
- Sderot Rothschild 9, Hadera
English ,Hebrew
Orot Rabin
- Car Service
- Closed Will open on Tuesday at 06:00
- רחוב 14, Hadera
English ,Hebrew
Hanan Motors
- Car ServiceAuto parts
- Closed Will open on Tuesday at 08:00
- Ha-Matekhet St 3, Hadera
English ,Hebrew ,Russian
Ha`Shlosha Hadera
- Car Service
- Closed Will open on Tuesday at 07:00
- Hadera
English ,Hebrew
Garage Shmulik
- Car Service
- Closed Will open on Tuesday at 08:00
- Yosef Meizer St 10, Hadera
English ,Hebrew
Auto Service Hadera
- Car Service
- Closed Will open on Tuesday at 08:00
- Friedlander St 12, Hadera
English ,Hebrew

Service Center Metro Ha`Sharon
- Car Service
- Closed Will open on Tuesday at 07:00
- HaUman St 10, Hadera
English ,Hebrew
Drive belt replacement
Drive belt replacement
The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.