Nozzle replacement in Hadera
42 companies found
Garage Moran
- Car Service
- Closed Will open on Thursday at 08:00
- Yosef Meizer St 8, Hadera
English ,Hebrew

Cohen Motors
- Showroom
- Closed Will open on Thursday at 08:30
- Manai St 1, Hadera
English ,Hebrew

Tsemed Ha'Tsafon
- Car Service
- Closed Will open on Thursday at 07:30
- Ba'alei Melakha St 17, Hadera, Israel
Euromotors
- Car Service
- Closed Will open on Thursday at 07:30
- HaMasger St 10, Hadera
English ,Hebrew
Aviv
- Car Service
- Closed Will open on Thursday at 08:00
- Sderot Rothschild 9, Hadera
English ,Hebrew
Ozeri Kasspi
- Car Service
- Closed Will open on Thursday at 08:30
- David Shimoni St 47, Hadera
English ,Hebrew
Cohen Motors Hadera
- ShowroomCar Service
- Closed Will open on Thursday at 08:30
- Manai St 1, Hadera
English ,Hebrew
Efi Et Bnei
- Car Service
- Closed Will open on Thursday at 07:30
- Combe St 6, Hadera
English ,Hebrew

Garage A.M. Hadera
- Car Service
- Closed Will open on Thursday at 08:00
- Yehudei Pki'in St 11, Hadera
English ,Hebrew
Garage Ihalom
- Car Service
- Closed Will open on Thursday at 08:00
- Friedlander St 12, Hadera
English ,Hebrew
Diesel Hadera
- Car Service
- Closed Will open on Thursday at 06:00
- Ha-Matekhet St 16, Hadera
English ,Hebrew ,Russian
Amit Cohen
- Car Service
- Closed Will open on Thursday at 07:30
- Friedlander St 10, Hadera
English ,Hebrew
Nozzle replacement
Nozzle replacement
It may be required to replace the nozzles in the presence of the following symptoms: rough engine operation, reduced power and poor acceleration, engine starting problems, engine failure at idle speed, sharp noises at the start, increased CO content in the exhaust gases, malfunctioning oxygen level sensor, increased fuel consumption. The nozzle replacement procedure involves turning off the power supply of the car, releasing the pressure in the fuel system, draining the excess, disconnecting the junction block, disassembling the fuel line, removing the intake manifold, removing the nozzle rail, dismantling the nozzle and releasing the sealing rings on the replaced nozzle. Once these operations are completed, the nozzles are replaced.