Timing chain replacement in Hadera
42 companies found
S.O.S. Sherutey Rehev
- ShowroomCar Service
- Closed Will open on Thursday at 07:00
- Combe St 12, Hadera
English ,Hebrew
Diesel Hadera
- Car Service
- Closed Will open on Thursday at 08:00
- Ha-Matekhet St 15, Hadera
English ,Hebrew
Yair Hadera
- Car Service
- Closed Will open on Thursday at 08:00
- Ha-Matekhet St 9, Hadera
English ,Hebrew
Garage Shmulik
- Car Service
- Closed Will open on Thursday at 08:00
- Yosef Meizer St 10, Hadera
English ,Hebrew
Casey Brothers Garage
- Car Service
- Closed Will open on Thursday at 07:30
- מוסך אחים קייסי
English ,Hebrew
Aviv
- Car Service
- Closed Will open on Thursday at 08:00
- Sderot Rothschild 9, Hadera
English ,Hebrew

Tsemed Ha'Tsafon
- Car Service
- Closed Will open on Thursday at 07:30
- Ba'alei Melakha St 17, Hadera, Israel
Diesel Hadera
- Car Service
- Closed Will open on Thursday at 06:00
- Ha-Matekhet St 16, Hadera
English ,Hebrew ,Russian
Mosah HaZemed
- Car Service
- Closed Will open on Thursday at 07:30
- Ba'alei Melakha St 25, Hadera
English ,Hebrew
Cohen Motors Hadera
- ShowroomCar Service
- Closed Will open on Thursday at 08:30
- Manai St 1, Hadera
English ,Hebrew
Auto Service Hadera
- Car Service
- Closed Will open on Thursday at 08:00
- Friedlander St 12, Hadera
English ,Hebrew

Garage Alex Hadera
- Car Service
- Closed Will open on Thursday at 07:30
- HaUman St 10, Hadera, Israel
English ,Hebrew ,Russian
Timing chain replacement
Timing chain replacement
A timing chain must be replaced in the event of wear of this component, which is detected during a routine inspection. To change the timing chain, it is required to disassemble the engine: disconnect the battery, drain the antifreeze, remove the drive belts and heater hoses, remove the crankshaft pulley, fan and water pump, align the mark on the old timing chain and dismantle. Install a new chain. For that, align the marks, install a new oil seal instead of the old one, then carry out the above operations in the reverse order to disassemble the engine and check the operability of the new belt.