- Home
- Haifa District
- Services
- Engine
- Valve cover gasket replacement
Valve cover gasket replacement in Haifa District
323 companies found
Garage Dror
- Car Service
- Closed Will open on Monday at 07:30
- Derech Haifa 6, Kiryat Ata
English ,Hebrew

Garage Start, Kiryat Ata
- Car Service
- Closed Will open on Monday at 08:00
- Ha-Ta'asiya St 38, Kiryat Ata, Israel
English ,Hebrew
Garage Ram
- Car Service
- Closed Will open on Monday at 08:00
- Bar Yehuda Road 32, Nesher
English ,Hebrew ,Russian

Car Service Ha-Merkaz Baqa Al-Gharbiya
- Car ServiceAuto parts
- Closed Will open on Monday at 07:30
- Ibn Khaldun, Baqa al-Gharbiyye
English ,Hebrew
Hasan Moasi Service
- Car Service
- Closed Will open on Monday at 08:00
- אל מקריזי בניין סנדיאן, Baka el-Garbiya
Hebrew
Mosah Meshmarot
- Car Service
- Closed Will open on Monday at 08:00
- Savyon St, Pardes Hanna-Karkur
English ,Hebrew

M.D.O
- Car Service
- Closed Will open on Monday at 08:00
- Derech Haifa 33, Kiryat Ata
Hebrew

Garage Autoban
- Car Service
- Closed Will open on Monday at 08:00
- HaHistadrut Ave 202, Haifa
English ,Hebrew ,Russian
Merkavim
- Car Service
- Closed Will open on Monday at 08:00
- Granit St 22, Caesarea
English ,Hebrew ,Russian

Garage Alex Hadera
- Car Service
- Closed Will open on Monday at 07:30
- HaUman St 10, Hadera, Israel
English ,Hebrew ,Russian

Bedek 2007
- Car Service
- Closed Will open on Monday at 08:00
- Industrial Zone, Akko Rd, Kiryat Bialik
English ,Hebrew
Sliva Akram
- Car Service
- Closed Will open on Monday at 08:00
- Edison St 15, Haifa
English ,Hebrew
Valve cover gasket replacement
Valve cover gasket replacement
The valve cover gasket should be replaced in the following cases: appearance of engine oil traces on the side walls of the cylinder head; assembling the engine after overhaul; detection of any gasket defects during repair. To replace the valve cover, disconnect the battery, remove the wire ends from the plugs, remove the valve cover attachments, remove the cover fasteners, remove the worn seal from the pockets, clean the working surface, apply a sealant and install a new gasket into the grooves.