- Home
- Herzliya
- Services
- Maintenance
- Drive belt replacement
Drive belt replacement in Herzliya
33 companies found
Techno Fiat
- Car Service
- Closed Will open on Sunday at 08:00
- Medinat ha-Yehudim St 68, Herzliya
English ,Hebrew
Ha-Dekel
- Car Service
- Closed Will open on Sunday at 07:30
- Galgalei ha-Plada St 14, Herzliya
English ,Hebrew
Marom
- Car Service
- Closed Will open at 08:00
- Medinat ha-Yehudim St 68, Herzliya
English ,Hebrew
Bentley Israel Service Center
- Car Service
- Closed Will open at 08:30
- Galgalei ha-Plada St 2, Herzliya
English ,Hebrew

Garage Amal
- Car Service
- Closed Will open at 08:00
- Tamar St 5, Herzliya, Israel
English ,Hebrew
Millennium Pituah Garage
- Car Service
- Closed Will open at 07:30
- Medinat ha-Yehudim St 95, Herzliya
English ,Hebrew

Tyres Center SH.I.
- Car ServiceTire serviceAuto parts
- Closed Will open at 07:30
- Hess St 27, Herzliya
English ,Hebrew

Techno Cycle
- Car Service
- Closed Will open at 07:30
- Ha-Khermesh St 3, Herzliya
English ,Hebrew
Garage Ha'Iona
- Car Service
- Closed Will open at 07:30
- Galgalei ha-Plada St 3, Herzliya
English ,Hebrew
Automotive-PST
- Car Service
- Closed Will open on Sunday at 09:00
- Ha-Sadna'ot St 5, Herzliya
English ,Hebrew
Ha'Sharon Garage
- ShowroomAuto parts
- Closed Will open on Sunday at 08:00
- Yad Harutsim St 5, Herzliya
English ,Hebrew

Aaron&Joshua
- Car Service
- Closed Will open on Sunday at 06:30
- Bareket St 7, Herzliya
English ,Hebrew
Drive belt replacement
Drive belt replacement
The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.