Timing chain replacement in Herzliya
27 companies found
Sun Motors
- Car Service
- Closed Will open on Wednesday at 07:30
- Galgalei ha-Plada St 23, Herzliya
English ,Hebrew
Doron&Yair
- Car Service
- Closed Will open on Wednesday at 07:30
- Maskit St 15, Herzliya
English ,Hebrew

Aaron&Joshua
- Car Service
- Closed Will open on Wednesday at 06:30
- Bareket St 7, Herzliya
English ,Hebrew
E.I. Musach Tiran
- Car Service
- Closed Will open on Wednesday at 07:30
- HaMada St 4, Herzliya |
English ,Hebrew

Automativi
- Car Service
- Closed Will open on Wednesday at 07:30
- Ha-Sadna'ot St 5, Herzliya
English ,Hebrew
Ha-Dekel
- Car Service
- Closed Will open on Wednesday at 07:30
- Galgalei ha-Plada St 14, Herzliya
English ,Hebrew
Porsche Israel Service Center
- Car Service
- Closed Will open on Wednesday at 08:00
- Hahoshlim St 11, Herzliya
English ,Hebrew
Garage Far
- Car Service
- Closed Will open on Wednesday at 07:30
- Hahoshlim St 1, Herzliya
English ,Hebrew

Marina Garage
- Car Service
- Closed Will open on Wednesday at 07:30
- Galgalei ha-Plada St 5, Herzliya
English ,Hebrew
Peer
- Car Service
- Closed Will open on Wednesday at 07:30
- Hahoshlim St 1, Herzliya
English ,Hebrew
Marom Herzliya
- Car Service
- Closed Will open on Wednesday at 07:30
- Medinat ha-Yehudim St 66, Herzliya
English ,Hebrew

Mosah Ha-Ir
- Car Service
- Closed Will open on Wednesday at 07:30
- Ha'Ilanot/Kanfe Nesharim, Herzliya
English ,Hebrew
Timing chain replacement
Timing chain replacement
A timing chain must be replaced in the event of wear of this component, which is detected during a routine inspection. To change the timing chain, it is required to disassemble the engine: disconnect the battery, drain the antifreeze, remove the drive belts and heater hoses, remove the crankshaft pulley, fan and water pump, align the mark on the old timing chain and dismantle. Install a new chain. For that, align the marks, install a new oil seal instead of the old one, then carry out the above operations in the reverse order to disassemble the engine and check the operability of the new belt.