Drive belt replacement in Jerusalem District
223 companies found

Garage Eitan Jerusalem
- Car Service
- Closed Will open on Sunday at 08:00
- Beit Ha-Defus St 30, Jerusalem
English ,Hebrew
Egged Hevra Jerusalem 4
- Car Service
- Closed Will open on Sunday at 08:00
- Shvil HaArie 10, Jerusalem
English ,Hebrew
Auto Vik
- Car Service
- Closed Will open on Sunday at 07:30
- HaUman St 19, Jerusalem
English ,Hebrew
Roy Motors
- Car Service
- Closed Will open on Sunday at 08:00
- Gas Station/Kedem Road, Ma'ale Adumim
English ,Hebrew

Drag Motorcycles
- ShowroomCar Service
- Closed Will open on Sunday at 09:00
- Shatner St 5, Jerusalem
English ,Hebrew
Garage Meir
- Car Service
- Closed Will open on Sunday at 08:00
- Shvil HaArie 9, Jerusalem
English ,Hebrew
Halatz
- Car Service
- Closed Will open on Sunday at 08:00
- Beit El St 8, Jerusalem
English ,Hebrew

Garage Amnon
- Car Service
- Closed Will open on Sunday at 08:00
- Beit Ha-Defus St 32, Jerusalem, Israel
English ,Hebrew
Ha`Mechonit
- Car Service
- Closed Will open on Sunday at 08:00
- Beit ha-Yotser St 6, Jerusalem
English ,Hebrew
Egged Hevra Jerusalem
- Car Service
- Closed Will open on Sunday at 08:00
- Ha-rav Aharon Kotler St 13, Jerusalem
English ,Hebrew
Adar
- Car Service
- Closed Will open on Sunday at 07:30
- Harashei Barzel St 1, Jerusalem
English ,Hebrew

Lev-Gan
- Car Service
- Closed Will open on Sunday at 07:30
- Beit ha-Yotser St 9, Jerusalem
English ,Russian
Drive belt replacement
Drive belt replacement
The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.