- Home
- Jerusalem District
- Services
- Air conditioning and heating
- Evaporator replacement
Evaporator replacement in Jerusalem District
213 companies found
Front Jerusalem
- Car Service
- Open Will close at 17:00
- Beit Ha-Defus St 22, Jerusalem, Israel
English ,Hebrew
Ha`Mechonit I-M
- Car Service
- Open Will close at 16:30
- Ha-Musakhim St 12, Jerusalem
English ,Hebrew
Garage City
- Car Service
- Open Will close at 17:00
- Yig'al Alon Ave 18, Beit Shemesh
English ,Hebrew
Hafetz Haim
- Car Service
- Open Will close at 17:00
- HaOfeh St 4, Jerusalem
English ,Hebrew
Sh.I.H.
- Car Service
- Open Will close at 17:00
- Beit Ha-Defus St 7, Jerusalem
English ,Hebrew
Teutsa
- Car Service
- Open Will close at 16:30
- Ha'Uman St 15, Jerusalem
English ,Hebrew
Micha Et Yoav
- Car Service
- Open Will close at 17:00
- HaRechev St 14, Jerusalem
English ,Hebrew
Nahum Yuzman Garage
- Car ServiceTire service
- Open Will close at 17:00
- 23, Zekharia
English ,Hebrew
Garage Ka.L. Electric
- Car Service
- Open Will close at 16:00
- Beit Ha-Defus St 18, Jerusalem, Israel
English ,Hebrew
Derech Erez
- Car Service
- Open Will close at 17:00
- Ha-Yetsira St 108, Mevaseret Zion
English ,Hebrew
Ha`Uman
- Car Service
- Open Will close at 16:00
- HaUman St 19, Jerusalem
English ,Hebrew
Garage Maale Ha'Hamisha
- Car Service
- Open Will close at 17:00
- Kibbutz Ma'ale HaHamisha, Ma'ale HaHamisha
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.