Nozzle replacement in Jerusalem District
200 companies found

Haim Levi 1998
- ShowroomCar ServiceTire service
- Closed Will open on Sunday at 07:30
- Ha-Rekhavim St 15, Jerusalem
English ,Hebrew
Service Center Lexus Jerusalem
- Car Service
- Closed Will open on Sunday at 08:30
- Kanfei Nesharim St 62, Jerusalem
English ,Hebrew
Garage Ha`Kfar Jerusalem
- Car Service
- Closed Will open on Sunday at 07:30
- HaPalmach St 1, Jerusalem, Israel
English ,Hebrew
Shimon
- Car Service
- Closed Will open on Sunday at 08:00
- Asirey Tsiyon St 6, Karnei Shomron
English ,Hebrew

Garage Amnon
- Car Service
- Closed Will open on Sunday at 08:00
- Beit Ha-Defus St 32, Jerusalem, Israel
English ,Hebrew
Ha`Uman
- Car Service
- Closed Will open on Sunday at 07:30
- HaUman St 19, Jerusalem
English ,Hebrew

Auto Forum
- Car Service
- Closed Will open on Sunday at 07:30
- HaRechev St 22, Jerusalem
Hebrew ,Russian
Garage Trucks Beit Shemesh
- Car Service
- Closed Will open on Sunday at 07:00
- מרכז שירות למשאיות בית שמש בע"מ
English ,Hebrew
Y.D Moto
- ShowroomCar Service
- Closed Will open on Sunday at 08:00
- Ha-Sadna St 7, Jerusalem
English ,Hebrew

Garage Automotors
- Car Service
- Closed Will open on Sunday at 08:00
- Har Tov St 2, Bet Shemesh
English ,Hebrew ,Russian
Ron
- Car Service
- Closed Will open on Sunday at 07:30
- Avraham Shalom Yehuda St 7, Jerusalem
English ,Hebrew
Lubinsky National Service Center, Jerusalem
- Car Service
- Closed Will open on Sunday at 07:00
- Yad Harutsim St 11, Jerusalem
English ,Hebrew
Nozzle replacement
Nozzle replacement
It may be required to replace the nozzles in the presence of the following symptoms: rough engine operation, reduced power and poor acceleration, engine starting problems, engine failure at idle speed, sharp noises at the start, increased CO content in the exhaust gases, malfunctioning oxygen level sensor, increased fuel consumption. The nozzle replacement procedure involves turning off the power supply of the car, releasing the pressure in the fuel system, draining the excess, disconnecting the junction block, disassembling the fuel line, removing the intake manifold, removing the nozzle rail, dismantling the nozzle and releasing the sealing rings on the replaced nozzle. Once these operations are completed, the nozzles are replaced.