ECU replacement
  1. Home
  2. Jerusalem
  3. Services
  4. Electrical equipment
  5. ECU replacement

ECU replacement in Jerusalem

149 companies found

Garage Yaser
  • Car Service
  • Closed Will open at 08:00
  • Totseret St 11, Jerusalem
  • English, Hebrew
Call now
Turin
  • Car Service
  • Closed Will open at 08:00
  • HaRechev St 2, Jerusalem
  • English, Hebrew
Call now
Garage Salah Jerusalem
  • Car Service
  • Closed Will open at 08:00
  • Totseret St 26, Jerusalem
  • English, Hebrew
Call now
Ha`Shemesh Ha`Ole
  • Car Service
  • Closed Will open at 07:30
  • Kanfei Nesharim St 23, Jerusalem
  • English, Hebrew
Call now
Dalhom Jerusalem
  • Car Service
  • Open
  • 191, Jerusalem
  • English, Hebrew
Call now
Garage Diesel
  • Car Service
  • Closed Will open at 08:00
  • Wadi al-Joz St 7, Jerusalem
  • English, Hebrew
Call now
Ha`Yozer
  • Car Service
  • Closed Will open at 08:00
  • Beit ha-Yotser St 7, Jerusalem
  • English, Hebrew
Call now
David Schrem
  • Car Service
  • Closed Will open at 08:00
  • Harashei Barzel St 6, Jerusalem
  • English, Hebrew
Call now
Service Center Azuri
  • Car Service
  • Closed Will open at 07:30
  • General Pierre Koenig St 40, Jerusalem
  • English, Hebrew
Call now
Barzilai
  • Car Service
  • Closed Will open at 07:30
  • Harashei Barzel St 13, Jerusalem
  • English, Hebrew
Call now
M. Forward
  • Car Service
  • Closed Will open at 08:30
  • Beit ha-Yotser St 8, Jerusalem
  • English, Hebrew
Call now
Shalom Dayan
  • Car Service
  • Closed Will open at 07:00
  • Beit Lehem Rd 144, Jerusalem
  • English, Hebrew
Call now
Show all companies

ECU replacement

A malfunction of the electronic control unit (ECU) is indicated by the “Check Engine” sensor, and computer diagnostics will be required to clarify the problem. The main symptoms of a malfunctioning ECU are such engine problems as a failure, inability to start. Replacing the engine control unit begins with determining its location. Before removing the unit, disconnect the battery, disconnect the blocks with wires from the control unit, remove the device and install a new one. After that, check the operability of the electronic control unit. It may be required to adapt the device.