Drive belt replacement

Drive belt replacement in Kfar Qasim

31 companies found

Garage Saba
  • Car Service
  • Closed Will open on Saturday at 08:00
  • ישוב, Kfar Qasem
  • English, Hebrew
Call now
Adi Motors
  • Car Service
  • Closed Will open on Sunday at 08:30
  • 5, Kfar Qasim, 4881000
  • English, Hebrew
Call now
Abu Albuch
  • Car Service
  • Closed Will open on Sunday at 08:00
  • 5, Kfar Qasim, 4881000
  • English, Hebrew
Call now
Garage Berry Motors
  • Car Service
  • Open Will close at 18:00
  • 5, Kfar Qasim, 4881000, Israel
  • English, Hebrew
Call now
Almog Kerman
  • Car Service
  • Closed Will open on Sunday at 07:30
  • 5, Kfar Qasim, 4881000
  • English, Hebrew
Call now
Thulin
  • Car Service
  • Closed Will open on Saturday at 08:00
  • Kfar Qasem
  • English, Hebrew
Call now
Rami Kfar Qasim
  • Car Service
  • Closed Will open on Sunday at 07:30
  • 9, Kfar Qasim
  • English, Hebrew
Call now
Essawi
  • Car Service
  • Closed Will open on Saturday at 07:15
  • 5, Kfar Qasim, 4881000
  • English, Hebrew
Call now
Gina Car Services
  • Car Service
  • Closed Will open on Saturday at 08:00
  • Abd el-Karim Qasem St 6608, Kfar Qasim
  • English, Hebrew
Call now
Gir Car
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Nof Haarez St 1, Rosh Haayin, 4881000
  • English, Hebrew
Call now
Yehiam Shirutei Sheda
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Nof Haarez St 1, Rosh Haayin, 4881000, Israel
  • English, Hebrew
Call now
Show all companies

Drive belt replacement

The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.