Nozzle replacement in Kfar Saba
33 companies found
Shuli
- Car Service
- Closed Will open on Monday at 08:00
- Ha-Kharoshet St 2, Kefar Sava
English ,Hebrew

Garage Sde Yaakov
- Car Service
- Closed Will open on Monday at 08:00
- Ha-Shikma St 30, Kefar Sava
English ,Hebrew
Bezek
- Car Service
- Closed Will open on Monday at 07:00
- Ha-Yotsrim St 10, Kefar Sava
English ,Hebrew
Tzemed Zakhar
- Car Service
- Closed Will open on Monday at 07:30
- HaMenofim St 8, Kefar Sava
English ,Hebrew

Saar Kfar Sava
- Car Service
- Closed Will open on Monday at 08:00
- מוסך סער
English ,Hebrew
Record
- Car Service
- Closed Will open on Monday at 08:00
- Ha-Kharoshet St 4, Kefar Sava
English ,Hebrew
Ha`Movil Fosfeld
- Car Service
- Closed Will open on Monday at 07:30
- Derech HaMovil 9, Kfar Saba
English ,Hebrew
Eliad
- Car Service
- Closed Will open on Monday at 08:00
- Ha-Nagar St 3, Kefar Sava
English ,Hebrew
Ha`Sharon Machon
- Car Service
- Closed Will open on Monday at 07:30
- HaTa'as St 11, Kefar Sava
English ,Hebrew
Garage Rabia
- Car Service
- Closed Will open on Monday at 07:30
- Yohanan HaSandlar St 17, Kefar Sava
English ,Hebrew
Garage Ha'Merkaz
- Car Service
- Closed Will open on Monday at 08:00
- Yohanan HaSandlar St 13, Kefar Sava
English ,Hebrew
Shalom&Shady
- Car Service
- Closed Will open on Monday at 08:30
- HaMenofim St 10, Kefar Sava
English ,Hebrew
Nozzle replacement
Nozzle replacement
It may be required to replace the nozzles in the presence of the following symptoms: rough engine operation, reduced power and poor acceleration, engine starting problems, engine failure at idle speed, sharp noises at the start, increased CO content in the exhaust gases, malfunctioning oxygen level sensor, increased fuel consumption. The nozzle replacement procedure involves turning off the power supply of the car, releasing the pressure in the fuel system, draining the excess, disconnecting the junction block, disassembling the fuel line, removing the intake manifold, removing the nozzle rail, dismantling the nozzle and releasing the sealing rings on the replaced nozzle. Once these operations are completed, the nozzles are replaced.