- Home
- Kiryat Ata
- Services
- Engine
- Timing chain replacement
Timing chain replacement in Kiryat Ata
20 companies found
Nasser Michel
- Car Service
- Closed Will open on Thursday at 08:00
- Keren HaYesod St 5, Kiryat Ata
English ,Hebrew
Ha`Nozez
- Car Service
- Closed Will open on Thursday at 07:30
- Derech Haifa 6, Kiryat Ata
English ,Hebrew
Daud Moris
- Car ServiceEvacuator
- Closed Will open on Thursday at 08:00
- Derech Deshanim 25, Kiryat Ata
English ,Hebrew
Fadida Transportations
- Car Service
- Closed Will open on Thursday at 05:00
- Shlomo Ben Yosef St 29, Kiryat Ata
English ,Hebrew
Garage Dudu
- Car Service
- Closed Will open on Thursday at 08:00
- Derech Haifa 27, Kiryat Ata
English ,Hebrew

Garage Start, Kiryat Ata
- Car Service
- Closed Will open on Thursday at 08:00
- Ha-Ta'asiya St 38, Kiryat Ata, Israel
English ,Hebrew
Garage Ha'Moil
- Car Service
- Closed Will open on Thursday at 08:00
- Derech Haifa 18, Kiryat Ata
English ,Hebrew
Garage Ha-Achim Kiryat Ata
- Car Service
- Closed Will open on Thursday at 08:00
- Derech Haifa 33, Kiryat Ata, Israel
English ,Hebrew

M.D.O
- Car Service
- Closed Will open on Thursday at 08:00
- Derech Haifa 33, Kiryat Ata
Hebrew
Halutzi
- Car Service
- Closed Will open on Thursday at 07:30
- Shlomo Ben Yosef St 26, Kiryat Ata
English ,Hebrew
Atias Zion
- Car Service
- Closed Will open on Thursday at 08:00
- Derech Haifa 6, Kiryat Ata
English ,Hebrew

Robert and Son
- Car Service
- Closed Will open on Thursday at 07:30
- מוסך רוברט ובנו
English ,Hebrew
Timing chain replacement
Timing chain replacement
A timing chain must be replaced in the event of wear of this component, which is detected during a routine inspection. To change the timing chain, it is required to disassemble the engine: disconnect the battery, drain the antifreeze, remove the drive belts and heater hoses, remove the crankshaft pulley, fan and water pump, align the mark on the old timing chain and dismantle. Install a new chain. For that, align the marks, install a new oil seal instead of the old one, then carry out the above operations in the reverse order to disassemble the engine and check the operability of the new belt.