- Home
- Kiryat Bialik
- Services
- Steering
- Steering gear replacement
Steering gear replacement in Kiryat Bialik
12 companies found
Meruts
- Car Service
- Closed Will open on Tuesday at 08:00
- Yosef Levi St 27, Kiryat Bialik
English ,Hebrew
Ha`Zafon Basol Ve Banav
- Car Service
- Closed Will open on Tuesday at 08:00
- Haroshet St 86, Kiryat Bialik
English ,Hebrew
Garage T.L.M Yossi
- Car Service
- Closed Will open on Tuesday at 07:30
- Haroshet St 30, Kiryat Bialik
English ,Hebrew
Gararge Sagi Raz Or
- Car Service
- Closed Will open on Tuesday at 08:00
- Ba'alei ha-Melakha St 5, Kiryat Bialik, Israel
English ,Hebrew
Akuka
- Car Service
- Closed Will open on Tuesday at 08:45
- HaSadna St 6, Kiryat Bialik
English ,Hebrew
Hish
- Car Service
- Closed Will open on Tuesday at 07:30
- HaSadna St 10, Kiryat Bialik
English ,Hebrew
Shlein&Banav
- Car Service
- Closed Will open on Tuesday at 07:30
- Yosef Levi St 32, Kiryat Bialik
English ,Hebrew
Bedek 2007
- Car Service
- Closed Will open on Tuesday at 08:00
- Industrial Zone, Akko Rd, Kiryat Bialik
English ,Hebrew
Mosah Ha-Totah
- Car Service
- Closed Will open on Tuesday at 08:00
- Haroshet St 17, Kiryat Bialik
English ,Hebrew
Garage Ha'Tsafon Basul Ve'Banav
- Car Service
- Closed Will open on Tuesday at 08:00
- Haroshet St 86, Kiryat Bialik
English ,Hebrew
Samir Nemora
- Car Service
- Closed Will open on Tuesday at 08:00
- Yosef Levi St 28, Kiryat Bialik
English ,Hebrew
Garage Dekel
- Car Service
- Closed Will open on Tuesday at 08:00
- Haroshet St 54, Kiryat Bialik
English ,Hebrew
Steering gear replacement
Steering gear replacement
It may be required to replace the steering gear if you notice the following signs: traces of oil under the car, steering wheel turning problems, steering wheel backlash, as well as knocking sounds in the gearbox. The general procedure for replacing a part is as follows: use a puller to remove the steering lever from the axle, remove the finishing panel located under the devices, disconnect the shaft from the gearbox, remove the thermal insulation shield, dismantle the gear and install a new one.