- Home
- Netanya
- Services
- Maintenance
- Drive belt replacement
Drive belt replacement in Netanya
86 companies found
Service Center Ampar
- Car Service
- Closed Will open on Tuesday at 07:00
- David Pinkas St 7, Netanya
English ,Hebrew ,Russian

Suzuki MSA Netanya
- ShowroomCar Service
- Open Will close at 17:30
- Ha-Plada St 26, Netanya
English ,Hebrew
Garage Elhan
- Car Service
- Closed Will open on Tuesday at 07:30
- HaKadar St 23, Netanya, Israel
English ,Hebrew
Tin Wave Tinkering
- Car Service
- Closed Will open on Tuesday at 07:00
- Ort St 19, Netanya
English ,Hebrew
Garage Avraam Netanya
- Car Service
- Closed Will open on Tuesday at 07:30
- Shechterman Tzvi St 6, Netanya
English ,Hebrew
Hachmon Aaron
- Car Service
- Closed Will open on Tuesday at 07:00
- Derech HaRakevet 6, Netanya
English ,Hebrew
Tobol Et Geresh
- Car Service
- Closed Will open on Tuesday at 07:30
- HaRechev St 2, Netanya
English ,Hebrew
Hai Sohniyot
- Car Service
- Open Will close at 18:00
- David Pinkas St 17, Netanya
English ,Hebrew
Mexico
- Car ServiceEvacuator
- Closed Will open on Tuesday at 07:30
- Ort St 19, Netanya
English ,Hebrew

Full Gas
- Car Service
- Open Will close at 17:00
- HaMerkava St 5, Netanya
English ,Hebrew ,Russian
Garage Far Netanya
- Car Service
- Closed Will open on Tuesday at 07:30
- Shechterman Tzvi St 4, Netanya
English ,Hebrew

Garage Ha'Ahim Netanya
- Car Service
- Closed Will open on Tuesday at 08:00
- HaOreg St 6, Netanya
English ,Hebrew
Drive belt replacement
Drive belt replacement
The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.