Nozzle replacement in Or Yehuda
12 companies found
Bechor Kohen Motors
- ShowroomCar Service
- Closed Will open on Sunday at 07:30
- Ha-Hagana St 18, Or Yehuda
English ,Hebrew
Garage Car Yosef
- Car Service
- Closed Will open on Sunday at 07:30
- Lod Road 5, Or Yehuda
English ,Hebrew
Garage Yitzhak
- Car Service
- Closed Will open on Sunday at 07:00
- HaTa'asiya St 2, Or Yehuda
English ,Hebrew
Shay Li
- Car Service
- Closed Will open on Sunday at 07:30
- Ha-Yozmim St 12, Or Yehuda
English ,Hebrew
Garage Ha-Yosemim
- Car Service
- Closed Will open on Sunday at 07:30
- Ha-Yozmim St 6, Or Yehuda, Israel
English ,Hebrew
Hanan&Shefik
- Car Service
- Closed Will open on Sunday at 06:30
- Khativat Alexandroni St 3, Or Yehuda
English ,Hebrew
Serbian Elijah
- Car Service
- Closed Will open on Sunday at 07:30
- HaYetsira St 11, Or Yehuda
English ,Hebrew
Si O Center
- Car Service
- Closed Will open on Sunday at 08:00
- Ha-Kharoshet St 26, Or Yehuda
English ,Hebrew
Shimon Arbiv
- Car Service
- Closed Will open on Sunday at 08:00
- Ha-Yozmim St 3, Or Yehuda
English ,Hebrew
Garage Yitzhak Giss
- Car Service
- Closed Will open on Sunday at 07:00
- Ha-Hagana St 4, Or Yehuda
English ,Hebrew
Armie Rauy
- Car Service
- Closed Will open on Sunday at 08:00
- Ha-Kharoshet St 6, Or Yehuda
English ,Hebrew
Garage Naftali Or Yehuda
- Car Service
- Closed Will open on Sunday at 07:30
- Ha-Yozmim St 11, Or Yehuda, Israel
English ,Hebrew
Nozzle replacement
Nozzle replacement
It may be required to replace the nozzles in the presence of the following symptoms: rough engine operation, reduced power and poor acceleration, engine starting problems, engine failure at idle speed, sharp noises at the start, increased CO content in the exhaust gases, malfunctioning oxygen level sensor, increased fuel consumption. The nozzle replacement procedure involves turning off the power supply of the car, releasing the pressure in the fuel system, draining the excess, disconnecting the junction block, disassembling the fuel line, removing the intake manifold, removing the nozzle rail, dismantling the nozzle and releasing the sealing rings on the replaced nozzle. Once these operations are completed, the nozzles are replaced.