Timing chain replacement in Or Yehuda
12 companies found
Serbian Elijah
- Car Service
- Closed Will open on Sunday at 07:30
- HaYetsira St 11, Or Yehuda
English ,Hebrew
Shimon Arbiv
- Car Service
- Closed Will open on Sunday at 08:00
- Ha-Yozmim St 3, Or Yehuda
English ,Hebrew
Garage Ha-Yosemim
- Car Service
- Closed Will open on Sunday at 07:30
- Ha-Yozmim St 6, Or Yehuda, Israel
English ,Hebrew
Garage Yitzhak Giss
- Car Service
- Closed Will open on Sunday at 07:00
- Ha-Hagana St 4, Or Yehuda
English ,Hebrew
Garage Car Yosef
- Car Service
- Closed Will open on Sunday at 07:30
- Lod Road 5, Or Yehuda
English ,Hebrew
Garage Naftali Or Yehuda
- Car Service
- Closed Will open on Sunday at 07:30
- Ha-Yozmim St 11, Or Yehuda, Israel
English ,Hebrew
Garage Yitzhak
- Car Service
- Closed Will open on Sunday at 07:00
- HaTa'asiya St 2, Or Yehuda
English ,Hebrew
Armie Rauy
- Car Service
- Closed Will open on Sunday at 08:00
- Ha-Kharoshet St 6, Or Yehuda
English ,Hebrew
Si O Center
- Car Service
- Closed Will open on Sunday at 08:00
- Ha-Kharoshet St 26, Or Yehuda
English ,Hebrew
Bechor Kohen Motors
- ShowroomCar Service
- Closed Will open on Sunday at 07:30
- Ha-Hagana St 18, Or Yehuda
English ,Hebrew
Hanan&Shefik
- Car Service
- Closed Will open on Sunday at 06:30
- Khativat Alexandroni St 3, Or Yehuda
English ,Hebrew
Shay Li
- Car Service
- Closed Will open on Sunday at 07:30
- Ha-Yozmim St 12, Or Yehuda
English ,Hebrew
Timing chain replacement
Timing chain replacement
A timing chain must be replaced in the event of wear of this component, which is detected during a routine inspection. To change the timing chain, it is required to disassemble the engine: disconnect the battery, drain the antifreeze, remove the drive belts and heater hoses, remove the crankshaft pulley, fan and water pump, align the mark on the old timing chain and dismantle. Install a new chain. For that, align the marks, install a new oil seal instead of the old one, then carry out the above operations in the reverse order to disassemble the engine and check the operability of the new belt.