Drive belt replacement

Drive belt replacement in Petah Tikva

117 companies found

Yossi Segal
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • Bar Kochva St 77, Petah Tikva
  • EnglishHebrew
Yosef Garage
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • Avshalom Gissin St 61, Petah Tikva
  • EnglishHebrew
Grand Garage
  • Car Service
  • Open Will close at 18:00
  • Emile Zola St 35, Petah Tikva
  • EnglishHebrewRussian
Ehut, Petah Tikva
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • Amal St 27, Petah Tikva
  • EnglishHebrew
Tzomet
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • 481 33, Petah Tikva
  • EnglishHebrew
G.M.S
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • Amal St 58, Petah Tikva
  • EnglishHebrew
Subaru National Service Center
  • Car Service
  • Closed Will open on Wednesday at 07:30
  • Avshalom Gissin St 80, Petah Tikva
  • EnglishHebrew
Naftali Motorcycles
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • Ben Tsiyon Galis St 17, Petah Tikva
  • EnglishHebrew
Gazit
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • Basel St 13, Petah Tikva
  • EnglishHebrew
Suzuki National Service Centre, Petah Tikva
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • St. Zeev Jabotinsky, corner of st. Albert Einstein, Petah Tikva
  • EnglishHebrew
Universal Truck
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • HaRakevet 9, Petah Tikva
  • EnglishHebrewRussian
Garage Aviv
  • Car Service
  • Closed Will open on Wednesday at 08:00
  • Ha-Rekhev St 14, Petah Tikva, Israel
  • EnglishHebrew

The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.