- Home
- Rehovot
- Services
- Air conditioning and heating
- Evaporator replacement
Evaporator replacement in Rehovot
56 companies found
Israel Tours
- Car Service
- Open Will close at 13:30
- Yetsira St 39, Rehovot
English ,Hebrew
Elimelech, Rehovot
- Car Service
- Open Will close at 13:00
- HaMapuach St 8, Rehovot
English ,Hebrew
Iriyat Rehovot
- Car Service
- Closed Will open on Sunday at 08:00
- Moti Kind St 3, Rehovot
English ,Hebrew
Shaldor
- Car Service
- Open Will close at 14:00
- HaHarash St 3, Ness Ziona
English ,Hebrew

Garage Or Alai
- Car Service
- Open Will close at 12:00
- Moshe Yatom St 13, Rehovot
English ,Hebrew
Garage Paz
- Car Service
- Open Will close at 15:00
- HaYam Road 23, Rehovot, Israel
English ,Hebrew
Roy Speed
- Car Service
- Open Will close at 13:00
- Moshe Yatom St 33, Rehovot
English ,Hebrew
Balmi Ha`Mirkaz
- Car ServiceAuto parts
- Closed Will open on Sunday at 08:00
- Galgal St 10, Rehovot
English ,Hebrew
Dayan Jacob
- Car Service
- Closed Will open on Sunday at 08:00
- Moshe Yatom St 7, Rehovot
English ,Russian
A.A. Yahav Garage
- Car Service
- Closed Will open on Sunday at 08:00
- Moti Kind St 3, Rehovot
English ,Hebrew
Shlomi Peretz
- Car Service
- Closed Will open on Sunday at 08:00
- Yetsira St 15, Rehovot
English ,Hebrew
H.T. Automotors
- Car Service
- Open Will close at 12:30
- Nehushtan St 2, Rehovot
English ,Hebrew
Evaporator replacement
Evaporator replacement
It may be required to repair the evaporator in the presence of the following signs: the presence of an unpleasant odor in the passenger compartment, which appears immediately after turning on the air conditioning system and disappears shortly after turning it off, the appearance of water in the passenger compartment, a decrease in the performance of the air conditioning system. To replace the evaporator, remove the heater block, which is located behind the dashboard. In order to replace the evaporator, disassemble the dashboard, remove the evaporator mounts and the unit. After that, install a new evaporator block. At the end of the procedure, check the state of the system.