Drive belt replacement in Israel
2765 companies found
Colmobil Hyunday Petah Tikva
- Car Service
- Closed Will open on Sunday at 07:30
- Avshalom Gissin St 78, Petah Tikva
English ,Hebrew
Service Center Rehev David
- Car Service
- Closed Will open on Sunday at 07:30
- Nirim St 8, Tel Aviv-Yafo
English ,Hebrew
Liad
- Car Service
- Closed Will open on Sunday at 08:00
- Matityahu
English ,Hebrew
Egged Hevra Bet Shemesh
- Car Service
- Closed Will open on Sunday at 08:00
- HaMelacha St 11, Bet Shemesh
English ,Hebrew
Garage A.A.Haim
- Car Service
- Closed Will open on Sunday at 08:00
- Bussy Saint Georges St 11, Kiryat Ekron, Israel
English ,Hebrew
Garage Hossam
- Car Service
- Closed Will open on Saturday at 07:30
- Ha-Melakha St 14, Afula
English ,Hebrew
Promotors Garage
- Car ServiceTire service
- Closed Will open on Sunday at 07:30
- Nir St 4
English ,Hebrew
Gold Motors Shilat
- Car Service
- Closed Will open on Sunday at 07:30
- Kfar Rut East Junction
English ,Hebrew
Garage M.M.
- Car Service
- Open Will close at 18:00
- Ibn Khaldun, Baqa al-Gharbiyye, Israel
English ,Hebrew
Eliza Automobile
- ShowroomCar Service
- Closed Will open on Sunday at 08:30
- Ha-Amal St 3, Netanya
English ,French ,Hebrew ,Russian
Park Motors Kfar Sava
- ShowroomCar Service
- Closed Will open on Sunday at 09:00
- HaTa'as St 11, Kefar Sava
English ,Hebrew
Olam Ha`Rechev
- Car Service
- Closed Will open on Sunday at 08:00
- Derech HaAtsma'ut 2, Yehud
English ,Hebrew
Drive belt replacement
Drive belt replacement
The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.