Drive belt replacement

Drive belt replacement in Tel Aviv District

481 companies found

Techno Motto
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Rashi St 8, Bnei Brak
  • English, Hebrew
Call now
Talkar
  • ShowroomCar Service
  • Closed Will open on Sunday at 08:30
  • HaMasger St 32, Tel Aviv-Yafo
  • English, Hebrew, Russian
Call now
Ha'Sharon Garage
  • ShowroomAuto parts
  • Closed Will open on Sunday at 08:00
  • Yad Harutsim St 5, Herzliya
  • English, Hebrew
Call now
Garage Avi Barda
  • Car Service
  • Closed Will open on Sunday at 08:00
  • HaKnesset St 8, Holon, Israel
  • English, Hebrew
Call now
H.M- motors
  • Car ServiceAuto parts
  • Closed Will open on Sunday at 07:30
  • Herzl St 113, Tel Aviv-Yafo
  • English, Hebrew
Call now
Amin Gar Zion
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Sderot Har Tsiyon 51, Tel Aviv-Yafo
  • English, Hebrew
Call now
Garage Far Tel Aviv
  • Car Service
  • Closed Will open on Sunday at 08:00
  • Etsyon Gever St 13, Tel Aviv-Yafo
  • English, Hebrew
Call now
Garage Mordechai
  • Car Service
  • Closed Will open on Sunday at 09:00
  • Shrira Ga'on St 6, Tel Aviv-Yafo
  • English, Hebrew
Call now
Sadna
  • Car Service
  • Closed Will open on Sunday at 09:00
  • Raoul Wallenberg St 14, Tel Aviv-Yafo
  • English, Hebrew
Call now
Dino Bike
  • ShowroomCar Service
  • Closed Will open on Sunday at 08:00
  • Bar Yokhai St 23, Tel Aviv-Yafo
  • English, Hebrew
Call now
Show all companies

Drive belt replacement

The drive belt is replaced if it is worn out, which can be indicated by such signs as a whistle when starting the engine or at high speeds, the indicator signals confirming a decrease in generator performance, the appearance of stains of oil, fuel and other operating fluids and cracks, scuffs, loose threads and other defects detected in the course of visual inspection. To replace the belt, disconnect the battery, unscrew the tension roller screw to loosen it and dismantle the belt from the camshaft, roller shafts and pump shaft. Dismantle the drive shaft retaining screw, and then remove the crankshaft pulley, the component drive fastener and the belt. Installation of the device is carried out in the reverse order.