- Home
- Tel Aviv District
- Services
- Engine
- Nozzle replacement
Nozzle replacement in Tel Aviv District
379 companies found
Amin Gar Zion
- Car Service
- Open Will close at 17:00
- Sderot Har Tsiyon 51, Tel Aviv-Yafo
English ,Hebrew
Garage Yamit
- Car Service
- Open Will close at 16:00
- HaNatsiv St 2, Tel Aviv-Yafo
English ,Hebrew
Garage Eitan Tel Aviv
- Car Service
- Open Will close at 16:45
- Shrira Ga'on St 6, Tel Aviv-Yafo
English ,Hebrew
Bentley Israel Service Center
- Car Service
- Closed Will open at 09:00
- Galgalei ha-Plada St 2, Herzliya
English ,Hebrew
Garage Van Motors
- Car Service
- Open Will close at 17:00
- Hayei Adam St 7, Tel Aviv-Yafo
English ,Hebrew ,Russian
Garage BMW Hadad
- ShowroomCar Service
- Open Will close at 17:00
- HaPeled St 17, Holon
English ,Hebrew
Aaron&Joshua
- Car Service
- Open Will close at 15:30
- Bareket St 7, Herzliya
English ,Hebrew
Garage Eli Et Eli
- Car ServiceAuto parts
- Open Will close at 17:00
- Ha-Mano'a St 8, Tel Aviv-Yafo
English ,Hebrew
Hochman
- Car Service
- Open Will close at 17:00
- Schnitzler St 27, Tel Aviv-Yafo
English ,Hebrew
Garage Hizkei
- Car Service
- Open Will close at 17:00
- Elisabeth Bergner St 11, Tel Aviv-Yafo
English ,Hebrew
Ha`Ach Ha`Gadol
- Car Service
- Open Will close at 17:30
- Gershon Shatz St 42, Tel Aviv-Yafo
English ,Hebrew
Garage Ha'Orgim
- Car Service
- Open Will close at 17:00
- Ha-Satat St 20, Holon
English ,Hebrew ,Russian
Nozzle replacement
Nozzle replacement
It may be required to replace the nozzles in the presence of the following symptoms: rough engine operation, reduced power and poor acceleration, engine starting problems, engine failure at idle speed, sharp noises at the start, increased CO content in the exhaust gases, malfunctioning oxygen level sensor, increased fuel consumption. The nozzle replacement procedure involves turning off the power supply of the car, releasing the pressure in the fuel system, draining the excess, disconnecting the junction block, disassembling the fuel line, removing the intake manifold, removing the nozzle rail, dismantling the nozzle and releasing the sealing rings on the replaced nozzle. Once these operations are completed, the nozzles are replaced.