Valve cover gasket replacement in Tel Aviv-Yafo
187 companies found
Efi Hashmal
- Car Service
- Closed Will open on Sunday at 08:00
- Ya'akov Wasserman St 5, Tel Aviv-Yafo
English ,Hebrew
Sagi Garage, Rival 19, Tel Aviv
- Car Service
- Closed Will open on Sunday at 08:00
- Rival St 19, Tel Aviv-Yafo
English ,Hebrew
Garage Samir Tel Aviv
- Car Service
- Closed Will open on Sunday at 08:00
- Yisra'el mi-Salant St 46, Tel Aviv-Yafo
English ,Hebrew

Garage Megan
- Car Service
- Closed Will open on Sunday at 08:00
- Tushiya St 20, Tel Aviv-Yafo
English ,Hebrew

Art Dream
- Car Service
- Closed Will open on Sunday at 08:00
- Hayei Adam St 9, Tel Aviv-Yafo, Israel
English ,Hebrew ,Russian
Edmund
- Car Service
- Closed Will open on Sunday at 08:30
- Yisra'el mi-Salant St 46, Tel Aviv-Yafo
English ,Hebrew
Garage Motty Ben Best
- Car Service
- Closed Will open on Sunday at 07:30
- Elisabeth Bergner St 13, Tel Aviv-Yafo, Israel
English ,Hebrew
Garage Hipushit
- Car Service
- Closed Will open on Sunday at 08:00
- Derekh Ben-Zvi 37, Tel Aviv-Yafo
English ,Hebrew
Service Centre Kalay
- Car Service
- Closed Will open on Sunday at 07:30
- Tversky St 7, Tel Aviv-Yafo
English ,Hebrew
Abu Daud
- Car Service
- Closed Will open on Sunday at 08:00
- Olei Zion St 15, Tel Aviv-Yafo
English
Eli Welder and Uri Eli Welder and Uri Milling Machine Operator
- Car Service
- Closed Will open on Sunday at 08:00
- Yitzhak Sadeh St 34, Tel Aviv-Yafo
English ,Hebrew

Yad Haruzim Auto Service
- Car Service
- Closed Will open on Sunday at 08:00
- Yad Harutsim St 8, Tel Aviv-Yafo
English ,Hebrew
Valve cover gasket replacement
Valve cover gasket replacement
The valve cover gasket should be replaced in the following cases: appearance of engine oil traces on the side walls of the cylinder head; assembling the engine after overhaul; detection of any gasket defects during repair. To replace the valve cover, disconnect the battery, remove the wire ends from the plugs, remove the valve cover attachments, remove the cover fasteners, remove the worn seal from the pockets, clean the working surface, apply a sealant and install a new gasket into the grooves.