Nozzle replacement in Yehud Monosson
30 companies found
Service Center Hyundai Yehud
- Car Service
- Closed Will open on Sunday at 07:30
- Shabazi St 21, Yehud-Monosson
English ,Hebrew
Car Zone
- Car Service
- Closed Will open on Sunday at 08:00
- Weizman St 33, Yehud-Monosson
English ,Hebrew
Garage Dori
- Car Service
- Closed Will open on Sunday at 07:30
- Altalef St 7, Yehud-Monosson
English ,Hebrew
Rotem Paz
- Car Service
- Closed Will open on Sunday at 07:30
- Altalef St 25, Yehud-Monosson
English ,Hebrew
Shimshon
- Car Service
- Closed Will open on Sunday at 07:30
- Derech HaAtsma'ut 24, Yehud
English ,Hebrew
Garage Ha'Atzmaut Yehud
- Car Service
- Closed Will open on Sunday at 07:30
- HaTa'asiya St 20, Yehud-Monosson
English ,Hebrew
Eddie Weiss
- Car Service
- Closed Will open on Sunday at 08:00
- Derech HaAtsma'ut 24, Yehud
English ,Hebrew

Garage Yossi Volkswagen
- Car Service
- Closed Will open on Sunday at 07:45
- Ibn Gabirol St 3, Yehud-Monosson
English ,Hebrew
Ha`Achim Mimun
- Car Service
- Closed Will open on Sunday at 07:30
- Derech HaAtsma'ut 45, Yehud
English ,Hebrew
Ha`Tsemed
- Car Service
- Closed Will open on Sunday at 07:30
- Altalef St 21, Yehud-Monosson
English ,Hebrew
Pozner
- Car ServiceTire serviceAuto parts
- Closed Will open on Sunday at 07:30
- Altalef St 9, Yehud-Monosson
English ,Hebrew
Garage Ron Kor
- Car Service
- Closed Will open on Sunday at 08:00
- Altalef St 3, Yehud-Monosson
English ,Hebrew
Nozzle replacement
Nozzle replacement
It may be required to replace the nozzles in the presence of the following symptoms: rough engine operation, reduced power and poor acceleration, engine starting problems, engine failure at idle speed, sharp noises at the start, increased CO content in the exhaust gases, malfunctioning oxygen level sensor, increased fuel consumption. The nozzle replacement procedure involves turning off the power supply of the car, releasing the pressure in the fuel system, draining the excess, disconnecting the junction block, disassembling the fuel line, removing the intake manifold, removing the nozzle rail, dismantling the nozzle and releasing the sealing rings on the replaced nozzle. Once these operations are completed, the nozzles are replaced.